We’d like to remind Forumites to please avoid political debate on the Forum.
This is to keep it a safe and useful space for MoneySaving discussions. Threads that are – or become – political in nature may be removed in line with the Forum’s rules. Thank you for your understanding.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
1000mm drill bits
Comments
-
Good job Dan-Dan has a thick skin ... 'bout 2" thick, by my measurements.
... Difficult to needle him, innit?0 -
You cant needle someone stupid enough to mis measure by 50 cm and then be stupid enough to tell the world about itNever, under any circumstances, take a sleeping pill and a laxative on the same night.0
-
Dan, it's honesty, not stupidity.
Stupidity, in the DIY sense, is buying a new Stanley knife to cut plasterboard when putting up a partition wall... hammering the last panel neatly in place... now, where did I put that shiny new knife? Oh, on the horizontal stud that I've just completely covered with plasterboard. It's still there, as far as I know. Then there was loosening a round lock out of a finger-size hole. I know it was a finger-sized hole, 'cos I poked said lock to knock it out. Took me about 20 minutes to then extricate my finger from the exactly-finger-sized-hole where it was now firmly wedged.
You are young, grasshopper. Wait 'till you've cocked up as much as I have......
So, who's brave enough to start a "Honestly, why did I ever start doing this?" thread?0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 352K Banking & Borrowing
- 253.5K Reduce Debt & Boost Income
- 454.2K Spending & Discounts
- 245K Work, Benefits & Business
- 600.6K Mortgages, Homes & Bills
- 177.4K Life & Family
- 258.8K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.6K Read-Only Boards