📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Using an extension lead.

Is it safe to plug my computer, monitor, modem and speakers into a switched extension lead? Don't want to set the house on fire but at the moment I have to crawl under the desk to get to the wall socket to switch everything off.
«13

Comments

  • rmg1
    rmg1 Posts: 3,159 Forumite
    Part of the Furniture 1,000 Posts Name Dropper
    Providing the total load doesn't exceed 13Amps, you'll be fine.
    I've got a similar setup at home (but my router is in a wall socket as it doesn't get switched off).
    :wall: Flagellation, necrophilia and bestiality - Am I flogging a dead horse? :wall:

    Any posts are my opinion and only that. Please read at your own risk.
  • I do and never had an issue I would however, make sure that the extension lead is a surge protected one - masterplug are quite affordable and they sell them in places like home bargains

    :)
  • Stooby2
    Stooby2 Posts: 1,195 Forumite
    Yes that's fine - they all draw quite a low current and will be ok on one extension lead. I have two monitors, tower PC, speakers, printer, usb hub, modem and NAS box on one 12 way extension without issue.

    I did add up the wattage of each item and it came to just under 9 amps on full load so well within the 13amp rating of the extention.
  • closed
    closed Posts: 10,886 Forumite
    surge protection is a waste of money imo
    !!
    > . !!!! ----> .
  • John_Gray
    John_Gray Posts: 5,845 Forumite
    Part of the Furniture 1,000 Posts Name Dropper Photogenic
    @Stooby2
    You draw 9 amps from a small collection of computer equipment? I would have been surprised if it was more than 2 amps from the list you give...
  • googler
    googler Posts: 16,103 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Combo Breaker
    Why do you feel the need to switch off at the wall socket?
  • bluesnake
    bluesnake Posts: 1,460 Forumite
    edited 8 January 2014 at 3:00PM
    Unless you have a few big, old crt vdu and hefty lasers you should be ok.

    Your plug should be able to take over 3000W

    this type are normally bad news, often go wrong, get bumped, get pulled out due to weight of leads
    311kgkpuqxl._sl500_aa300_.jpg

    These tend to be more reliable
    00149799.jpg
  • Lomast
    Lomast Posts: 873 Forumite
    Part of the Furniture 500 Posts Name Dropper
    John_Gray wrote: »
    @Stooby2
    You draw 9 amps from a small collection of computer equipment? I would have been surprised if it was more than 2 amps from the list you give...


    I suspect the printer maybe a lot of that as my laser draws 1500w (approx 6A) when printing
  • pmartin86
    pmartin86 Posts: 776 Forumite
    Part of the Furniture 500 Posts Name Dropper
    closed wrote: »
    surge protection is a waste of money imo

    I thought that once until a storm waved bye bye to my PSU and motherboard, cost of circa £200 to replace and the humble £15~ surge protector seemed ironically cheap in hindsight!
  • closed
    closed Posts: 10,886 Forumite
    edited 8 January 2014 at 4:54PM
    do you expect a surge protector to do anything worthwhile in that scenario.

    Millions of tv's/pc's and a whole lot else are running happily for decades around the country without a surge protector
    !!
    > . !!!! ----> .
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 351.4K Banking & Borrowing
  • 253.3K Reduce Debt & Boost Income
  • 453.8K Spending & Discounts
  • 244.4K Work, Benefits & Business
  • 599.7K Mortgages, Homes & Bills
  • 177.1K Life & Family
  • 258K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.2K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.