📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Small job no.1

I have some jobs that are a daily annoyance that I haven't been able to solve so would be grateful for some ideas.

I have a glass porch with a heavy sliding door. To fill the gap between the paving and door sill and piece of wood has been put in by previous owners.. When it rains it swells making the door hard to slide.

1000012503.jpg

Coating it with wood preserver helped.

Unfortunately after that I replaced the end block paving with concrete adhesive because not cement worked. The end sticks out and I can't get the wood out.

1000012506.jpg

The wood now needs recoating but - I can no longer slide it out because the end block is just a tad too far out.

Can't slide it the other way because of a trim on the frame.

1000012508.jpg

I need to be able to either have a gizmo to sand down the wood while in situe where the runners go or ...…......

I can rise and shine - just not at the same time!

viral kindness .....kindness is contageous pass it on

The only normal people you know are the ones you don’t know very well


«13

Comments

  • Boohoo
    Boohoo Posts: 2,659
    Part of the Furniture 1,000 Posts Name Dropper
    Forumite

    Who installed the block paving?

    Is the wood to stop the pavers from moving as it should have edging stone on the edge and not wood.

    If you can't get it out due to moisture there should be a few days of dry weather for a few days so could dry out.

    Other option is to remove pavers next to the wood.

  • Section62
    Section62 Posts: 11,955
    10,000 Posts Fifth Anniversary Name Dropper
    Forumite

    If you can slide the opening leaf of the doors back as far as it can go then there might just be enough slack to allow the 'paver' end of the piece of wood to be lifted up and slid out over the top of the paver.

    But the amount you can slide the door back (open) is limited by the fixed stop, and that the internal handle will probably clash with the inner (fixed) leaf of the door. This can be overcome by temporarily removing the stop and the handle

    But before attempting that, beware because the (shiny silver) bottom slider track stops short of the end, so with the stop and handle removed it is likely the door will be free to drop off the end of the track and may then just fall out of the frame (this is one of the methods used to install/remove the doors on some designs).

    It would be a minimum two-person job, and really needs someone who knows what they are doing with patio doors and would be able to (safely) re-rail the door if it does come off the end. The doors are heavy and can do a lot of damage to fingers and other stuff if they aren't handled carefully.

    If pushing the door back as far as it will go without removing the stop isn't enough to wriggle the piece of wood out then don't try what I've said without getting help from people who know what they are doing.

  • Section62
    Section62 Posts: 11,955
    10,000 Posts Fifth Anniversary Name Dropper
    Forumite

    Is the wood to stop the pavers from moving as it should have edging stone on the edge and not wood.

    I'm guessing it has been added just to make the door more wheelchair-friendly, or to stop people twisting their ankle in the gap.

  • stuart45
    stuart45 Posts: 5,433
    Eighth Anniversary 1,000 Posts Name Dropper
    Forumite
    edited 30 October at 12:56PM

    There are methods of doing level thresholds for wheelchair access on new builds. I haven't seen that one used before though.

    Technical Details: An Architect's Guide To Level Thresholds - Architizer Journal

  • Boohoo
    Boohoo Posts: 2,659
    Part of the Furniture 1,000 Posts Name Dropper
    Forumite

    I see that the top bit is nailed on top of bottom bit of wood.

    Could you try to prose off the top bit?

    What ever you do you are going to have to let the wood dry out completely before applying any paint/preserver 1st after you have trimmed the bit near the door.

  • twopenny
    twopenny Posts: 9,499
    Part of the Furniture 1,000 Posts Name Dropper Photogenic
    Forumite
    edited 30 October at 1:31PM

    Section that was spot on in your last post.

    The porch was for a wheelchair. The ramp is block paving on, probably rubble filler. A real cheap job. But it works sort of.

    Getting the block off now would be very difficult.

    I will find out how much it will cost to get the door out because I think the bottom wheels? Ball-bearings? Are in need of replacement. I was initially told the whole porch and bay window would have to be replaced but seems from more recent enquiry I could just have the door done.

    My only hope it seems is to try and shave out the wooden bit but I need an attachment for a drill to sand it out. Needs to be specific because of the narrow space.

    Ah the nails. I tried to hammer them to tighten but they are tight. It's been there 27 years.

    Stew, that's a thought but it goes under the door so can't be removed upward.

    1000012513.jpg

    I can rise and shine - just not at the same time!

    viral kindness .....kindness is contageous pass it on

    The only normal people you know are the ones you don’t know very well


  • Boohoo
    Boohoo Posts: 2,659
    Part of the Furniture 1,000 Posts Name Dropper
    Forumite

    There should be some anti- lift locks at the top slider door that somehow comes off so you can lift the door off the track.

    You will need 2 people as it's heavy and have some old carpet or cardboard to rest the door on when out and carefully lower onto it's side/edge to get access to the runners and the wood.

  • twopenny
    twopenny Posts: 9,499
    Part of the Furniture 1,000 Posts Name Dropper Photogenic
    Forumite

    "There should be some anti- lift locks at the top slider door that somehow comes off so you can lift the door off the track."

    Did I mention the cheap and shoddy build? 🙂 All except for the bit of wood which is perfectly made and fitted 🙄 No there isn't a way to lift the door.

    I can rise and shine - just not at the same time!

    viral kindness .....kindness is contageous pass it on

    The only normal people you know are the ones you don’t know very well


  • Boohoo
    Boohoo Posts: 2,659
    Part of the Furniture 1,000 Posts Name Dropper
    Forumite

    How did the door get onto the silver runner then?

    Show a photo of the top of door when open on the inside there maybe a block there.

    Some have them on the door .

    A photo of the top runner will do.

  • You could always dry the wood out quicker with a heat gun or even a hairdryer .

★ ★ ★ Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 356K Banking & Borrowing
  • 255K Reduce Debt & Boost Income
  • 456.3K Spending & Discounts
  • 248.5K Work, Benefits & Business
  • 606.2K Mortgages, Homes & Bills
  • 179.1K Life & Family
  • 264K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.2K Discuss & Feedback
  • 37.7K Read-Only Boards
Quick Search

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.