SHOWER HEAD HOLDER REPLACEMENT

philtheman379

ThisIsWeird said:

https://www.ebay.co.uk/itm/162113273602?
Sometimes these things will come up on auction, so could be less.

Yes I saqw that, only thing that puts me off is it has a point sticking out, mine is a bar, but thanks anyway

philtheman379

ThisIsWeird said:

Really, Mira?! 18 and 19mm versions?!
https://www.ebay.co.uk/itm/182180399675?
Lawdie. 

Will this fit my shower riser rail? It is the cheapest of what I have been looking at, the next is almost £6 more
Thanks

philtheman379

ThisIsWeird said:

Really, Mira?! 18 and 19mm versions?!
https://www.ebay.co.uk/itm/182180399675?
Lawdie. 

This item is only for 19mm pipes, ansd I am sure mine is 18mm

philtheman379

philtheman379 said:

ThisIsWeird said:

Really, Mira?! 18 and 19mm versions?!
https://www.ebay.co.uk/itm/182180399675?
Lawdie. 

Will this fit my shower riser rail? It is the cheapest of what I have been looking at, the next is almost £6 more
Thanks

Spoke to seller will only fit a 19mm pipe so no go

philtheman379

What are your thoughts on this one?:
https://i.ebayimg.com/images/g/w1EAAOSw~Y1lCHxY/s-l1600.jpg

philtheman379 said:

What are your thoughts on this one?:
https://i.ebayimg.com/images/g/w1EAAOSw~Y1lCHxY/s-l1600.jpg
It is priced at £18.53 for 18mm, i have looked at loads so hoping that this one might be okay

Mira Coda L11 18mm Rail Shower Head Clamp Bracket Holder Chrome - 1630.036

Mira L11 Coda 18mm shower head holder - chrome (1630.036) 

 

Genuine spare part.  Also known as a shower head / hand shower / hand set holder.

Designed to fit most 18mm rails.  In polished chrome.

 

Fits the below Mira products:-
 

Mira Coda EV MK2 Thermostatic Bar Mixer Shower

Mira Coda MK2 (2006-2010)

Mira Coda MK2 (2006-2010)

Mira L11 Fittings Shower Rail Sets

ThisIsWeird

I would expect it to fit ok. I mean, how many different hose-fitting tapers does Mira have!

It's not very pretty, tho'...

philtheman379

Thanks for all your help and advice, will let you know once I have managed to get it in bits, fitted and put back together (hopefully!)

ThisIsWeird

If not too late, I'd be tempted to try https://www.notjusttaps.co.uk/shower-head-slider-bracket-18mm.html

philtheman379

ThisIsWeird said:

If not too late, I'd be tempted to try https://www.notjusttaps.co.uk/shower-head-slider-bracket-18mm.html

Unfortunately it is, I have ordered, thanks anyway

philtheman379

All done, top pipe was a '!!!!!!' seized, did some WD40 and left it, then cloth around the pipe and twisted the top pipe and eventually it gave.  The 'pin' just needed a slight tap to get it out, the bottom of the pipe had two flat edges so easy to undo, but had to be careful not twisting too far, overall really chuffed it is all done and gleaming.
Thanks again for all the advice (ThisIsWeird ) much appreciated.
Until the next time.......