Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Gas meter readings
hypokratis
Posts: 31
Forumite
Very confusing since my meter dated1991 has 3 different cu ft units printed on the face of the meter
The meter is also a type U6
In multiplying one of the units shown on the meter face (212cu.ft/ hour ) x 0.0283 one gets 6 (rounded up) as in 6 cu.metres/ hour which confirms conveniently the U6 meter type ?
In multiplying one of the units shown on the meter face (212cu.ft/ hour ) x 0.0283 one gets 6 (rounded up) as in 6 cu.metres/ hour which confirms conveniently the U6 meter type ?
Surprised that this issue has not been clarified by now from other forum users but I am a newcomer for now. Just pleased oddly enough that my new gas supplier agrees that the conversion factor using my meter is 0.0283 ???? Thanks everyone who responded. I will wait for the Ombudsman’s verdict and then get on with my life !
0
Comments
-
As a new user you may not be aware but you do not create new threads for each comment you make. You reply to the same thread you created at the start.Plus, as mentioned previously, you are posting in the wrong section.I am an Independent Financial Adviser (IFA). The comments I make are just my opinion and are for discussion purposes only. They are not financial advice and you should not treat them as such. If you feel an area discussed may be relevant to you, then please seek advice from an Independent Financial Adviser local to you.1
-
hypokratis said:In multiplying one of the units shown on the meter face (212cu.ft/ hour ) x 0.0283 one gets 6 (rounded up) as in 6 cu.metres/ hour which confirms conveniently the U6 meter type ?Yes, 212 cu.ft / hour or 6 cubic metres / hour is the maximum flow rate that the meter can support, but it's completely irrelevant to how you read the meter and how to convert the imperial value to metric.A car's speedometer might certified for a maximum speed of 200mph but the figure is unrelated to the conversion that would be used to get the kph equivalent.0
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards