📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

New Black Car - Marked it rubbing bird droppings off grrr!

Options
2

Comments

  • LandyAndy
    LandyAndy Posts: 26,377 Forumite
    Part of the Furniture 10,000 Posts
    colino wrote: »
    Neighbours still laugh when I cover the birdlime (lovely non-offensive word) with soaked squares of kitchen roll. An hour later, gently swirl off with more water.
    If the paint has went grey however, I'd get the local paintshop to have a look, as it sounds like you've went through the laquer coat into the colour coat.

    Same here, always works a treat. Makes the car look like a shaving accident but so what.
  • johnnyroper
    johnnyroper Posts: 1,592 Forumite
    Hey Strider... It was the first time Ive ever used washing up liquid on the car and it was only on that small bit. It was just a sponge I used but I did scrub hard I guess :(

    Will use t-cut to remove the scratches and polish the whole thing at the weekend after a good hand wash...

    This is what I get for having a drive under a load of trees! Bought a car cover yesterday too :)

    what you have done there is the same as using some fine wet and dry on the clear coat and put lots of very fine scratches on it,unless you used some 80grit it is unlikely you got through to the colour coat.
    first off you need to remove the bird !!!!!! i find spraying with traffic film remover first to soften and then a pressure washer normally gets it off for me.

    dont bother with t-cut as it is crap get some G3 compound it is whats used after wet sanding to gain shine in clear coat.if that dont remove scratches then you are looking at bodyshop job just remember after cutting back with the compound it will need polishing again.
  • maninthestreet
    maninthestreet Posts: 16,127 Forumite
    Part of the Furniture
    edited 14 July 2010 at 4:20PM
    I've taken some pictures of the damage.. bought some t-cut at lunch and plan to apply just a bit to a small part of the damage to see if it works.. or I'll call chipsaway and get a quote if that's better to do?

    http://i7.photobucket.com/albums/y281/MercilessKiller/IMG_0838.jpg
    http://i7.photobucket.com/albums/y281/MercilessKiller/IMG_0839.jpg
    http://i7.photobucket.com/albums/y281/MercilessKiller/IMG_0840.jpg

    The car is metallic black.. Grey sky and clouds make it look a bit strange but bear that in mind :)

    I would say that light grey part in 0839.jpg IS the undercoat - looks like you've removed all the black topcoat in that area.

    EDIT - or is it just a reflection of a cloud???
    "You were only supposed to blow the bl**dy doors off!!"
  • 23rdian
    23rdian Posts: 95 Forumite
    Part of the Furniture 10 Posts Combo Breaker
    What a mess. Did you rub it with an angle grinder?
  • MercilessKiller
    MercilessKiller Posts: 7,143 Forumite
    Part of the Furniture 1,000 Posts Combo Breaker
    Just a sponge... It is a load of little scratches so if you rub your finger from the glossy bit to the grey bit it goes from a glossy feel to a very very smooth feel..

    When wet you can hardly see the scartches either.

    Chipsaway have quoted me £90 to do some wet sanding then a polishing job or something and said that should restore most of the shinyness.

    Should I go for it?
    [FONT=Arial, Helvetica, sans-serif]"The internet is a great way to get on the net."
    - Bob Dole, Republican presidential candidate
    [/FONT]
  • The question you should ask Chipsaway is "if I book you to do this job, will you completely remove any discolouration and scratches?"
  • 23rdian
    23rdian Posts: 95 Forumite
    Part of the Furniture 10 Posts Combo Breaker

    When wet you can hardly see the scartches either.

    Chipsaway have quoted me £90 to do some wet sanding then a polishing job or something and said that should restore most of the shinyness.

    Should I go for it?

    Ah just drive it when it's raining then.

    Seriously, I think you need someone who knows what they are doing.

    I understand chipsaway are franchises so you might get someone very good or someone who might give it another "rub with a sponge"
  • johnnyroper
    johnnyroper Posts: 1,592 Forumite
    as said in my post use some G3 compound to remove scratches then polish again it should remove most if not all of the scratches.
    that is all chipsaway will do anyway,if you do yourself some compound will cost under a tenner and then just a bit of effort required
  • pimento
    pimento Posts: 6,243 Forumite
    Part of the Furniture 1,000 Posts
    Gawd! I'm glad I saw this thread before I washed my (almost) brand new black metallic car...
    "If you think it's expensive to hire a professional to do the job, wait until you hire an amateur." -- Red Adair
  • aqueoushumour01
    aqueoushumour01 Posts: 1,687 Forumite
    Hey Strider... It was the first time Ive ever used washing up liquid on the car and it was only on that small bit. It was just a sponge I used but I did scrub hard I guess :(

    Will use t-cut to remove the scratches and polish the whole thing at the weekend after a good hand wash...

    This is what I get for having a drive under a load of trees! Bought a car cover yesterday too :)

    which version of t cut have you got? You'll need to metallic one
    :D
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 351.2K Banking & Borrowing
  • 253.2K Reduce Debt & Boost Income
  • 453.7K Spending & Discounts
  • 244.2K Work, Benefits & Business
  • 599.3K Mortgages, Homes & Bills
  • 177.1K Life & Family
  • 257.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.2K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.