We'd like to remind Forumites to please avoid political debate on the Forum... Read More »
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Easier to set of in 2nd rather than 1st
Options

newfoundglory
Posts: 1,912 Forumite


in Motoring
I've only been driving with my own car for about 3 weeks. I've realised my car stalls when setting off in 1st unless there are sufficient revs. But, on my way to work this morning I discovered it's easier and smoother to set off in
2nd and is less prone to stalling if there isn't much gas.
It's not quite what I expected and am I likely to cause any damage by doing this?
2nd and is less prone to stalling if there isn't much gas.
It's not quite what I expected and am I likely to cause any damage by doing this?
0
Comments
-
newfoundglory wrote: »I've only been driving with my own car for about 3 weeks. I've realised my car stalls when setting off in 1st unless there are sufficient revs. But, on my way to work this morning I discovered it's easier and smoother to set off in
2nd and is less prone to stalling if there isn't much gas.
It's not quite what I expected and am I likely to cause any damage by doing this?
Youe likely to strain the tranmission by regularly using 2nd gear to move off from stationary."You were only supposed to blow the bl**dy doors off!!"0 -
and you will struggle to pull away at all if you are heading uphill. Unless you drive only in Norfolk and are married to someone who fixes clutches for a living, I'd practice pulling away in 1st until you can do it without stalling.0
-
It all depends on the car and the circumstances. Some vehicles that are relatively underpowered for their size are really low geared in 1st. (You'll recognise this when you have to change up to 2nd quickly after moving off when still doing relatively low speeds).
The engine/gearbox might not be a great match and the manufacturers have to plan for the once-in-a-blue-moon, fully-laden, hill start.
As long as your not using excessive revs and slipping the clutch it will be fine to use 2nd to move off on the flat.0 -
It all depends on the car and the circumstances. Some vehicles that are relatively underpowered for their size are really low geared in 1st. (You'll recognise this when you have to change up to 2nd quickly after moving off when still doing relatively low speeds).
The engine/gearbox might not be a great match and the manufacturers have to plan for the once-in-a-blue-moon, fully-laden, hill start.
As long as your not using excessive revs and slipping the clutch it will be fine to use 2nd to move off on the flat.
Unless there is something fundamentally wrong with the car, it should not stall in 1st gear when moving off from a standstill."You were only supposed to blow the bl**dy doors off!!"0 -
If you're already rolling then using 2nd instead of 1st is fine.
If you're pulling away then your description doesn't make much sense really.Happy chappy0 -
How slow a roll is considered safe for 2nd gear? If I'm under 5mph, as a general rule I'll go for 2nd gear. I have always wondered if this was best practice though.
Sorry for the thread hijack.This is my signature. There are many like it, but this one is mine.0 -
How slow a roll is considered safe for 2nd gear? If I'm under 5mph, as a general rule I'll go for 2nd gear. I have always wondered if this was best practice though.
Sorry for the thread hijack.
In my experience you can tell if the car liked to set off from a roll in second gear or not because if rolling too slow and then try to move off in second the engine becomes very laboured.0 -
You will burn the clutch out pulling away in 2nd, If its a newer car with a dual mass flywheel that wont last long either.Censorship Reigns Supreme in Troll City...0
-
You'll increase clutch wear but that's about it.0
-
Okay, maybe I didnt explain this too well.
Its possible to move off without stalling by coming up really slowly on the clutch. Its possible to move with no gas at all. But if you want to go more quickly, obviously some gas is needed. In my case 1500 revs causes it to virtually stall... so nearer 2000 revs is needed. In which case it pulls away really quite fast and you need to go to 2nd almost immediately anyway.
It just seemed to me to make more sense to start in 2nd, as its smoother and more controlled.0
This discussion has been closed.
Confirm your email address to Create Threads and Reply

Categories
- All Categories
- 351.1K Banking & Borrowing
- 253.2K Reduce Debt & Boost Income
- 453.6K Spending & Discounts
- 244.1K Work, Benefits & Business
- 599.1K Mortgages, Homes & Bills
- 177K Life & Family
- 257.5K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.1K Discuss & Feedback
- 37.6K Read-Only Boards