Aynsley clock insert replacement

ATC111

Size: insert part c.29mm, bezel c.35mm

Have looked online, eBay Amazon et al and no luck for this size.

Does anyone know where to get one of these? 

YellowCarBlueCar

I think you'll struggle to be honest without digging deeper.  That clock 'module' that you've taken out will contain a quartz or mechanical (my guess based on the crown) movement, and that's the but you'd need to replace.  Do you know that it's beyond repair?  Might just need a service...

mandy47

I had the same problem and never found a replacement. I still have the main china body but not the clock. Kept it just in case I ever find a replacement insert. I will be watching this thread with interest in case you find one.  
Good luck

Norman_Castle

ATC111 said:

Size: insert part c.29mm, bezel c.35mm

Whats "c"? These are normally measured by the diameter.

YellowCarBlueCar

The closest you'll get will be something like
https://www.cousinsuk.com/product/time-round-mini-025mm-to-055mm
If it's a mechanical i.e. wind-up movement then it probably just needs a service, which is basically a strip down, clean, and re-lubrication.

Carnmore

Norman_Castle said:

ATC111 said:

Size: insert part c.29mm, bezel c.35mm

Whats "c"? These are normally measured by the diameter.

C is for Circa..

ATC111

YellowCarBlueCar said:

The closest you'll get will be something like
https://www.cousinsuk.com/product/time-round-mini-025mm-to-055mm
If it's a mechanical i.e. wind-up movement then it probably just needs a service, which is basically a strip down, clean, and re-lubrication.

Thank you. They have a 30mm x 28mm and was about to order but the Trustpilot reviews for the company are poor!

Norman_Castle

Carnmore said:

Norman_Castle said:

ATC111 said:

Size: insert part c.29mm, bezel c.35mm

Whats "c"? These are normally measured by the diameter.

C is for Circa..

Normally it is but that doesn't relate to a dimension.

YellowCarBlueCar

ATC111 said:

YellowCarBlueCar said:

The closest you'll get will be something like
https://www.cousinsuk.com/product/time-round-mini-025mm-to-055mm
If it's a mechanical i.e. wind-up movement then it probably just needs a service, which is basically a strip down, clean, and re-lubrication.

Thank you. They have a 30mm x 28mm and was about to order but the Trustpilot reviews for the company are poor!

It's a company I've used many times with no issues.  They are a trade supplier to jewellers and watch/clock makers, so probably don't have the customer service you might get from a retailer. I have no other connection with the, other than buying supplies from them.

coffeehound

Presumably the back end diameter?

ATC111

coffeehound said:

Presumably the back end diameter?

Not sure what you're referring to?