Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
danfoss thermostat
norbert25
Posts: 6 Forumite
Can someone please offer some advice I have a danfoss themostat installed in a property Iv'e moved into. The heating apears to have been working for the week Iv'e been here, but it's been on for most of the day today. I initally had the thermostat set to all day mode and when I came back tonight it was off. I put the thermostat up and it clicked but nothing happened, Iv'e now put the thermostat in on mode and again turned the thermostat on the wall which clicked but again nothing's happening. When I put the thermostat down it's curruntly clciking at 15 degrees when going up and down so it seems to recgonise the tempature in the house but again the boiler isn't firing up when I go over it. Could this indicate an issue or have I got the thermostat set wrong?, I'm not used to it so not entiely sure if I'm using it correctly. Any help would be greatly appricated as I'm freezing.
0
Comments
-
A model number of the thermostat & timer/control would be useful along with a bit of info about the boiler.
At a guess, I'd say the boiler is at fault - Possibly a gas valve or sensor. In which case, you will want to call a Gas Safe registered heating engineer out to take a look.Any language construct that forces such insanity in this case should be abandoned without regrets. –
Erik Aronesty, 2014
Treasure the moments that you have. Savour them for as long as you can for they will never come back again.0 -
Unless we're talking about a wireless thermostat that's lost touch with its receiver, my guess is that the problem is 99% likely to be with the boiler. The thermostat is calling for heat and the boiler isn't responding.
Check the boiler and see if it has any error codes showing. It may just need a reboot (did the gas go off for any reason?), or the system pressure could be too low (you might be able to resolve this yourself if you can find the filling loop).
As above, make & model number of boiler and any error code showing will help with a diagnosis.0 -
Danfoss make dozens of different types of thermostat, so it would help if you told us which one you've got (model/type number). The same goes with the boiler, the number of manufactures and model types mus run into the 100's so a bit of a clue might get you a better response than random guessesNever under estimate the power of stupid people in large numbers0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards

