Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
pennco boiler won't fire up
hoader
Posts: 1 Newbie
Hi there
The thermostat is calling for heat and the pilot light is lit. Power is going to the boiler but and the 24 volt transformer is working. The circulating pump is off. The boiler is a Pennco 15b070fv. Power from the thermostat and through the aquastat is good. There is a relay in the control box and does not click when I turn the power on and off. The relay does work Circuitry behind the circuit board in the control box is a mystery to me. It also has an electrically controlled damper on the stack and it won't open. I checked continuity of the damper motor and it's not burned out and is not getting power. The schematic shows a fuse in the control box but I can't find it. Rather not try to dismantle the control box. Maybe something is preventing the stack from opening. It looks like a synchronous motor so how does it reverse to close? 4 wires run between the stack and control panel with 2 being the 24 volt supply. I am stumped. :mad:
Any ideas? Thanks Hoader
The thermostat is calling for heat and the pilot light is lit. Power is going to the boiler but and the 24 volt transformer is working. The circulating pump is off. The boiler is a Pennco 15b070fv. Power from the thermostat and through the aquastat is good. There is a relay in the control box and does not click when I turn the power on and off. The relay does work Circuitry behind the circuit board in the control box is a mystery to me. It also has an electrically controlled damper on the stack and it won't open. I checked continuity of the damper motor and it's not burned out and is not getting power. The schematic shows a fuse in the control box but I can't find it. Rather not try to dismantle the control box. Maybe something is preventing the stack from opening. It looks like a synchronous motor so how does it reverse to close? 4 wires run between the stack and control panel with 2 being the 24 volt supply. I am stumped. :mad:
Any ideas? Thanks Hoader
0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards