📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Bathroom Extractor fan - How to keep water out?

Options
2»

Comments

  • muckybutt
    muckybutt Posts: 3,761 Forumite
    Part of the Furniture Combo Breaker
    Daronfitz wrote: »
    I presume this would need to be fitted at the fan end and a waste pipe fed through to exit the external wall somewhere?

    Fit it a few inches above the vent in the ceiling like in the photo, the condensate pipe will need to go outside somewhere yes, or if you have an internal stack it can go into that.
    You may click thanks if you found my advice useful
  • Mankysteve
    Mankysteve Posts: 4,257 Forumite
    Part of the Furniture 1,000 Posts Combo Breaker
    Xeorix wrote: »
    To put it simply, that shouldn't happen, however the good news is that it should be a simple fix!


    Secondly, get into the loft and look at the pipe. I'd expect its a soft coil, if it is, try slightly raising it which will create a curve upwards which should stop any water travelling down the pipe

    I wouldn't put a curve in it would act as water trap. Need to cure the cause.
    Which will be something wrong with outer cover.
  • Xeorix
    Xeorix Posts: 385 Forumite
    Mankysteve wrote: »
    I wouldn't put a curve in it would act as water trap. Need to cure the cause.
    Which will be something wrong with outer cover.

    You removed my first point about the outer cover in your quote :)

    1) Outer cover
    2) Curve the pipe

    That is, assuming this water is rain water as it sounds, and not condensation as others have suggested
    Cashback
    Total Quidco since 2007: £166.64
    Total TCB since 2012: £398

    Competition Wins
    5* Break in Scotland
  • Had a look at the pipe while fitting the new fan yesterday. It looks like it is just a solid vertical pipe. I assume it has some type of cap on the external end but it was dark and I couldn't see the top. would explain why I can't see a grill on the outside wall though.
  • Xeorix
    Xeorix Posts: 385 Forumite
    Daronfitz wrote: »
    Had a look at the pipe while fitting the new fan yesterday. It looks like it is just a solid vertical pipe. I assume it has some type of cap on the external end but it was dark and I couldn't see the top. would explain why I can't see a grill on the outside wall though.

    Another assumption, but does this go out through a raised/vented tile in the roof then? Would look something like:
    https://www.google.co.uk/search?q=tile+vent&safe=off&espv=2&biw=1680&bih=928&source=lnms&tbm=isch&sa=X&ei=EzG-VL3_AqTV7gbQ74CABQ&ved=0CAcQ_AUoAg

    If so, then you either have a leak, or the most probable option as other have suggested - condensation.

    I'm not entirely sure how you're going to fit it, if you have no roof access though. You're going to need to attach it to the vent which you might be able to do through the hole in the ceiling, but then you'll have to connect the condensation drip pipe to something, usually out through the wall.

    Might have to measure up where the pipe would go outside, and drill from the outside in, feed the pipe through, hope it doesn't get stuck on anything and then connect it through the hole in the ceiling
    Cashback
    Total Quidco since 2007: £166.64
    Total TCB since 2012: £398

    Competition Wins
    5* Break in Scotland
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 351.2K Banking & Borrowing
  • 253.2K Reduce Debt & Boost Income
  • 453.7K Spending & Discounts
  • 244.2K Work, Benefits & Business
  • 599.2K Mortgages, Homes & Bills
  • 177K Life & Family
  • 257.6K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.