Where can I buy Bolts?

callistris

I sell them at work, I would be happy to send some out to you if you want them

M12 x 40mm 1.25 thread 10.9 79p each plus a small bit of postage.

PM me if you're still stuck:D

vaio

ailuro2 wrote: »

......Dependant on your skill level and the part involved you could drill and tap the current hole to take an M12 standard pitch bolt.( As long as you know what you're doing, that is)

Sounds like a really bad idea, re-tapping a M12 x 1.25 so it takes a M12 x 1.75 is not going to have anywhere near the required strength.

But that would make the 8.8 v 10.9 TS discussion a bit academic

You could drill out oversize and put a helicoil in if there is enough meat but it would be way easier to just get the right bolts

skiddlydiddly

I've ordered bolts off ebay a few times.Saves traipsing around looking for the right ones and generally pretty cheap.