The Forum is currently experiencing technical issues which the team are working to resolve. Thank you for your patience.

tricky solar pressure vessel!

hello.

I had a look at a solar install today where the cleint is complaining of eratic pressure on the gauge, as i watched the system, the pressure dipped between 0.5 bar and 6 bar.

i checekd the pressure vessel, this had 1.2 bar pressure(system, pressure released). i also re-flushed the system for air and very little air was found!

the system is a std two pannel system (low water content) with approx 8mtrs 16mm twin pipe flexi pipe, the pressure vessel is a 12ltr size.

pump working ok, when flushed no resistance on the system was noted and flushed through at aprrox 2bar, just for good measure i changed the gauge, but seemed to make little difference?!

any ideas??

Bruce2110
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350K Banking & Borrowing
  • 252.7K Reduce Debt & Boost Income
  • 453.1K Spending & Discounts
  • 242.9K Work, Benefits & Business
  • 619.8K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.9K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.