radiator p%^&*ng me off

can anyone on here with plumbing experience help me with a query?we got our house built 5 years ago and the heating is fine except for one radiator in the main bathroom which airlocks after about 2 weeks I bleed all the air out and it works fine again,then after another 2 weeks.............
I was wondering why only this radiator and no other? and where does the air keep coming from? is there anyway to cure it permanently?
counting down the time I got left.:beer::beer:

Comments

  • gas4you
    gas4you Posts: 2,602 Forumite
    What type of heating system/boiler do you have?
  • macman
    macman Posts: 53,129 Forumite
    Part of the Furniture 10,000 Posts Name Dropper
    It's not the rad itself. Once air gets into the system it rises to the highest point-which I'm guessing is your upstairs bathroom rad.
    No free lunch, and no free laptop ;)
  • This may be worth a try. If you shut off every other radiator except the troublesome one, it should force all the air out.
  • Lokolo
    Lokolo Posts: 20,861 Forumite
    Part of the Furniture 10,000 Posts
    You know what, mines exactly the same, and I wondered why it's always just that one. Thanks!
  • How is the air getting into the system, I have the same thing but as I live in a town house its the top three radiators, they need bleeding at least once a week and i would guess that at least half of each rad is filled with air before being bleed so where did the water from those rads go
  • Pincher
    Pincher Posts: 6,552 Forumite
    1,000 Posts Combo Breaker
    Automatic bleed valve?
  • If they keep filling with air, try holding a lighter to the bleed outlet. If it lights it'll probably be hydrogen which would indicate that the system is rotting. If that is the case, drain it all down and add inhibitor (sentinel x100 for example) and refill the system.
  • MrVirus wrote: »
    If they keep filling with air, try holding a lighter to the bleed outlet. If it lights it'll probably be hydrogen which would indicate that the system is rotting. If that is the case, drain it all down and add inhibitor (sentinel x100 for example) and refill the system.

    It would only be hydrogen if water was being lost through a leak somewhere and fresh water water being constantly added as top up from the header tank . Once the system is in use any free air should be driven off (which is what needs venting) and the system contents then do not corrode the radiators unless fresh water is introduced for some reason.
    You scullion! You rampallian! You fustilarian! I’ll tickle your catastrophe (Henry IV part 2)
  • A mispositioned pump could be drawing air down the vent pipe. Without seeing the system it's pretty hard to say. Also, if the pump was 'pumping over' (forcing air up the vent) this would aerate the water.

    Turning the pump speed down could cure both of these.
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350.1K Banking & Borrowing
  • 252.8K Reduce Debt & Boost Income
  • 453.1K Spending & Discounts
  • 243.1K Work, Benefits & Business
  • 597.4K Mortgages, Homes & Bills
  • 176.5K Life & Family
  • 256K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.