Gloss paint on walls

I have been horrified to find that underneath the wallpaper in my kitchen someone has painted the walls with Gloss dark green paint. Im fairly sure that the same may be lurking under the hallway paper also.

How on earth can I get over this. Is it a simple case of painting over or do I need to sand paper it off.

I think I need a lie down just thinking about the potential horror of having to sand it down

Help!!!!!!!
«1

Comments

  • hungrynurse_2
    hungrynurse_2 Posts: 251 Forumite
    is the wall paper in good condition? If so just paint over it, they did it on 60 minute makeover last week! Failing that, I would just paint over it, then paint over it, then paint over it, then paint over it, then paint over it until you see little green. Toss up between using cheap white emulsion or something more expesive which will need less coats, or you could test someone on their '1 cost guarantee'!
  • TomsMom
    TomsMom Posts: 4,251 Forumite
    Part of the Furniture 1,000 Posts Combo Breaker
    Nitromors. We had the exact same thing in the house we've just renovated. One of our builders was removing wallpaper on the stairs wall and found gloss paint underneath. It came off OK with Nitromors. The wall has now had lining paper put on and emulsioned (it wasn't in a good enough state to just emulsion straight onto the plaster).
  • Nitromors never heard of this but I will look into it. Thanks for replies, sounds like we have our work cut out arhhhhhhh
  • tbw
    tbw Posts: 5,137 Forumite
    Nitromors never heard of this but I will look into it. Thanks for replies, sounds like we have our work cut out arhhhhhhh


    Its an old established brand of paint stripper. Its very strong so be careful with it - if it disolves paint just imagine what it does to your skin ! Personally I wouldn't even consider using it on a big area like a wall - I've only used it for stripping small areas of wood or old furniture a section at a time. Paint it on with a brush, wait for it to strat bubbling and then scrape it off. I think I'd just rub the wall down well to 'key' it and then start painting over it.
    ELITE 5:2
    # 42
    11st2lbs down to 9st2lbs - another 5lbs gone due to alcohol abuse (head down toilet syndrome)
  • never_enough
    never_enough Posts: 1,495 Forumite
    Agree with tbw, nitromors is too toxic to use on large areas, you'll gas yourself, it's foul. If you do decide you must use it, ventilation is the key & do a small bit at a time.
    I have managed to paint emulsion over gloss on walls but the gloss was in good condition. It's not the best solution, but it was all I could bear to do at the time.
  • nickj_2
    nickj_2 Posts: 7,052 Forumite
    edited 17 May 2009 at 9:26AM
    Nitromors never heard of this but I will look into it. Thanks for replies, sounds like we have our work cut out arhhhhhhh

    using nitromors inside is extremely dangerous as it gives of harmful vapours especially if you are using it on large areas - you can either give it a good sand down and wash , then give it a coat of undercoat - then emulsion , or there are water based paint strippers

    health and safety data here- https://www.henkel-technical-services.co.uk/tech.php?brandID=9
  • THanks for all replies. I have looked into Nitromors and I agree that it will be far too toxic for the amount I need to remove and the enclosed space of my GF Flat.

    Do you think if I rubbed it down with sandpaper this would remove the gloss? walls are uneven in kitchen so I may just decide to paper over again.

    Thanks again
  • ormus
    ormus Posts: 42,714 Forumite
    certainly be very wary of using nitromors. outside ok but indoors id only use it in an empty house.
    sand it down as best you can, and paper over the top should suffice in most cases.
    Get some gorm.
  • paullwill8
    paullwill8 Posts: 488 Forumite
    What are you wanting to re-paint the walls with, emulsion?
    What goes around - comes around
    give lots and you will always recieve lots
  • nickj_2
    nickj_2 Posts: 7,052 Forumite
    there's no need to totally remove the gloss
    just give it a sand to give undercoat something to key onto
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350K Banking & Borrowing
  • 252.7K Reduce Debt & Boost Income
  • 453.1K Spending & Discounts
  • 243K Work, Benefits & Business
  • 619.9K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.9K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.