We’d like to remind Forumites to please avoid political debate on the Forum.

This is to keep it a safe and useful space for MoneySaving discussions. Threads that are – or become – political in nature may be removed in line with the Forum’s rules. Thank you for your understanding.

📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

computer clock loosing time

Anybody out there know why the clock on my 'puter looses time.Iread an article that said there's a battery on the motherboard that maintains the clock.Anybody know anything about these.i.e.Type/ease of replacement.(I'm assuming if it's on the motherboard it's probably soldered to it) Any help/advice on this would be greatfully appreciated.
«13

Comments

  • Hours and eventually days
  • This one should be easy,

    pop the side off your case (you may need to unscrew the back, also don't do this if you have warranty on it).

    Next take a look at the motherboard and you'll see a round silver disk like an only camera or watch battery.

    This is the battery which needs replacing. You should be able to read what it is without removing it so you can get a replacement and swap them over.

    Make sure you are touching an unpainted part of your case before touching anything else inside as this will ground you and protect against static. Also of course make sure the computer is unplugged.
  • loaner wrote: »
    http://www.computerhope.com/issues/ch000239.htm

    if it is connected to the net, set it to automatically sync, and it shouldn't be a problem, but they are usually 3V CR2032 or 3032 watch batteries, available for a couple of quid, +/- 1.50, depending where you buy them from

    If it is exact hours out, check your timezone.

    Agreed - CMOS replacement
  • Marty_J
    Marty_J Posts: 6,594 Forumite
    pop the side off your case (you may need to unscrew the back, also don't do this if you have warranty on it).

    Opening a computer shouldn't void its warranty. PCs are full of user replaceable parts.
    Make sure you are touching an unpainted part of your case before touching anything else inside as this will ground you and protect against static. Also of course make sure the computer is unplugged.

    How does touching an unpainted part of the case ground you if the computer is not plugged in?
  • Marty_J wrote: »
    Opening a computer shouldn't void its warranty. PCs are full of user replaceable parts.

    Opening a branded computer (eg Dell) inside its warranty will almost certainly void said warranty.
    Marty_J wrote: »
    How does touching an unpainted part of the case ground you if the computer is not plugged in?

    http://www.wikihow.com/Ground-Yourself-to-Avoid-Destroying-a-Computer-with-Electrostatic-Discharge

    Also apologies I meant unpowered i.e turn the power supply off.
  • Marty_J
    Marty_J Posts: 6,594 Forumite
    Opening a branded computer (eg Dell) inside its warranty will almost certainly void said warranty.

    Dell won't cover any "damage caused by incorrect installation, use, modifications or repair by any unauthorised 3rd party or yourself" (Apple is the same), but opening the case doesn't void the warranty. Computers are user-serviceable.
    Also apologies I meant unpowered i.e turn the power supply off.
    That's better. :p
  • Marty_J wrote: »

    Dell won't cover any "damage caused by incorrect installation, use, modifications or repair by any unauthorised 3rd party or yourself" (Apple is the same), but opening the case doesn't void the warranty. Computers are user-serviceable.

    (Does that mean that I void the warranty by (correctly) installing additional DDR RAM? Or is "damage" required before the void is effected?)

    Anyway, I had the same problem a while back, and in my case, it was the computer battery (as others have suggested) at fault. But it was a very easy repair job and I have had no problems since... Fingers crossed! ;)
    For the avoidance of doubt: I work for an IFA.
  • Marty_J
    Marty_J Posts: 6,594 Forumite
    Myrmidon_J wrote: »
    (Does that mean that I void the warranty by (correctly) installing additional DDR RAM? Or is "damage" required before the void is effected?)

    It means that if you try to change the RAM and you accidentally break something, then the warranty won't cover its repair.
  • Marty_J wrote:

    It means that if you try to change the RAM and you accidentally break something, then the warranty won't cover its repair.

    That's fair enough.
    Leopard wrote: »


    Excuse me but...

    Why is everybody automatically assuming that this newbie OP has a Windows PC?

    At what point has he/she ever indicated that the computer involved is not a Mac?

    The OP mentioned a motherboard...

    I heard that Macs operated some kind of magic box instead; elves and pixies and whatnot - not a motherboard in sight!

    Bigotry indeed. :p

    (More likely that the computer clock on a Mac doesn't run down, alas...)
    For the avoidance of doubt: I work for an IFA.
  • Marty_J
    Marty_J Posts: 6,594 Forumite
    Leopard wrote: »

    Fortyaday,

    Welcome to the MSE forum. You are most welcome.


    Everybody else,

    Excuse me but...

    Why is everybody automatically assuming that this newbie OP has a Windows PC?

    At what point has he/she ever indicated that the computer involved is not a Mac?

    Nowhere.

    Presumption and bigotry rules in this forum.

    Think about it. :cool:

    Did anyone give any advice which is not applicable to Macs?
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 352.1K Banking & Borrowing
  • 253.6K Reduce Debt & Boost Income
  • 454.2K Spending & Discounts
  • 245.2K Work, Benefits & Business
  • 600.8K Mortgages, Homes & Bills
  • 177.5K Life & Family
  • 259K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16K Discuss & Feedback
  • 37.7K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.