Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Fireplace lintel
We are planning to install a new inset electric fire into our brick chimney which involves putting in a new, wider lintel. Travis Perkins list concrete lintels which are suitable for fireplaces. Can we just assume that an R15 lintel of appropriate length is strong enough to hold the single skin brickwork above it, rather than employ a structural engineer to calculate it?
The new fire is 870mm wide so we were planning to put a 1200mm wide lintel in. (It currently has a standard 16" x 22" opening with a 620mm lintel above it).
Comments
-
Can we just assume that an R15 lintel of appropriate length is strong enough to hold the single skin brickwork above it, rather than employ a structural engineer to calculate it?
No, you need a structural engineer.
It isn't just the length and spec of the lintel, the capacity and stability of the walls supporting the lintel also need to be checked.
The chimney itself is a significant mass of masonry, but in many buildings the chimney also acts as a means of achieving lateral stability. Making a big hole near the base of such a structure needs to be treated as high risk.
The work will also require building control signoff, and the BCO will expect to see SE calculations confirming the proposed lintel is an adequate structural solution.
1 -
Thanks for the quick reply. You've really surprised me with that response. We used to have a back boiler in it from way back that was replaced in 2003 and they just whacked in a lintel and no-one from Buildings Control came out. The chimney opening was 960mm then and had to be filled in for a standard size gas fire. All the fireplace company said was that we might need to re-lintel it.
0 -
People doing work like boiler or fireplace installs can sometimes be economical with the truth when it comes to compliance with building regs. Similar to window replacement firms. They can sign off their own work if it comes under one of the schemes, but a structural alteration involving enlarging an opening and installing a new lintel does require signoff.
1 -
Do you need to cut into the structural jambs each side of the fireplace to get the lintel in?
1 -
Wwould it make any difference to
No.
0 -
Will the lintel be sitting on the non structural infill? Have you got a photo?
0 -
Can you help with how I attach photos?
0 -
Can you help with how to attach photos? I've never done it before.
0 -
There's an upload image 4 back from the smiley face.
1 -
Here they are. The plasterboard shows the visible size of the new fire. The original opening just has one brick on each outer part of the chimney (like a one brick wide pillar) and the rest of it was filled in by the company who replaced ourboriginak.back boiler with a replacement one in 2003.
0
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards

