Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Help to fit a wooden floor
Help to fit a wooden floor
Years ago I ascertained some hard wood flooring from my company, it was originally laid in 1973. I carefully removed the flooring also keeping some of the clasp nails. Now I intend to fit the flooring to my room and find I need more nails, searched online also building suppliers with no joy, estimated quantity 200+ required. I also need some guidance on where to start from, do I butt up to the patio door and work from there, the wood is tongue and groove photos enclosed.
Any help would be most appreciated.
Comments
-
50mm clasp nails are available from places like Screwfix, not exactly the same but you won’t notice once hammered down. Personally I would look at concealed screw fixing rather than nails.
0 -
You can also get flooring brad nails, or rosehead nails for an older look.
0 -
When I extracted the nails from the original floor the clasp nails were concealed being nailed diagonally through the tongue of the wood, photo enclosed. The clasp nails are measured in imperial, it is the width 1/16” I am unable to locate, sizes come much wider and would not be suitable with wood splitting.
0 -
You can use 18gauge brad nails for secret nailing of T&G flooring.
0 -
Hire a manual floor nailer
0 -
I am hesitant/wary regards using a Brad gun due to breaking and splitting the tongues of the wood. Also with Brad nails there is no head, therefore would they tend not to hold with foot traffic, I know the nails are going in at a angle.
0 -
The manual nailer is designed to put the nails in at an angle.
0 -
stuart45
Thank you for your advice which was very helpful and i will be taking your recommendation regards fixing.
Thank you all appreciate your input.
0
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards
