📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Boarding with plasterboard but without skimming - joints?

2»

Comments

  • Section62
    Section62 Posts: 11,944
    10,000 Posts Fifth Anniversary Name Dropper
    Forumite

    One possible issue is how to screw the p'board edges down, as screw heads will look nasty on the trims.

    With a trim like the one you linked to (with the back side of the 'H' being wider) it is possible to nail/screw through the back side into the stud, so long as the studs align with the board edges. The protrusion of the head of the nail/screw needs to be the least possible, so personally I'd use 30mm wire nails - drilling the plastic so it doesn't split, and using a punch to tap the nails home so the hammer doesn't damage the front side of the trim.

  • stuart45
    stuart45 Posts: 5,424
    Eighth Anniversary 1,000 Posts Name Dropper
    Forumite

    https://www.victorianplumbing.co.uk/monza-shower-wall-panel-h-joint-white-pvc?preSelected=true&s_kwcid=AL%2115853%213%21%21e%21%21o%214576167425276808

    You might be better off with this one. It's 2.4M in length and will take a 10mm board. As plasterboard is 9.5mm thick, it might be a tight fit getting them into trim that's designed for 9mm.

  • jonnydeppiwish!
    jonnydeppiwish! Posts: 1,537
    Part of the Furniture 1,000 Posts Mortgage-free Glee! Name Dropper
    Forumite

    they do it in the US all the time. Tape, fill and sand 👍

    2006 LBM £28,000+ in debt.
    2021 mortgage and debt free, working part time and living the dream
  • FreeBear
    FreeBear Posts: 18,926
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    Forumite

    "They" are doing it over here, especially with the (not so) cheap boxes that are being thrown up fast. Doesn't need skilled professionals. Just whack the Fill & Finish on, quick whizz over with a power sander, job done.

    Having done a bit of plastering here, it isn't that difficult to use Multifinish. Always, always use a fresh bag (they have a manufacture date printed on the side). Mix to a fairly stiff consistency, and trowel it on the wall straight away. A vertical, the horizontal pass with a Speedskim levels it off. Clean up the tools & buckets, then mix a second batch of plaster. Again, slap it on the wall and give it a couple of passes with the Speedskim. Clean the tools & buckets a second time and have a five minute coffee break. On returning, the plaster should be firm to touch. A light spray of water as you go over with a finishing trowel (one or two passes only) should get you a nice finish. A small wet paint brush run up and down a corner will sort out that area - Again, a couple of passes with a trowel is all that is needed to smooth things out.

    The mistakes most people do are -

    • Use old plaster - Anything older than 3 months should be left on the shelf. And if it is being stored in damp conditions, buy elsewhere.
    • Adding water to plaster - Wrong. plaster should only ever be added to clean water when mixing.
    • Using dirty buckets and/or water - Clean water only, and make sure tools & buckets are clean before starting.
    • Over working the plaster once it is on the wall. Learn patience, and drink more coffee. You only need to trowel the plaster a couple of times.
    • If you are patching a wall, use a damp sponge float to feather the edges in.
    • Use SBR, not PVA for suction control and bonding on old walls.
    • Multifinish should only go on at most, 3mm thick in two coats, If you need thicker layers, put a bonding coat on first.
    • Never sand back Multifinish when it is dry - If you have rough areas, run a damp sponge float over it while the plaster is still "green". Then use a finishing trowel to lightly rework the area. Just a couple of passes..

    Check your local adult education department - You'll find some offer short courses on plastering and other DIY subjects. Mine did a free one spread over a few afternoons.

    Any language construct that forces such insanity in this case should be abandoned without regrets. –
    Erik Aronesty, 2014

    Treasure the moments that you have. Savour them for as long as you can for they will never come back again.
★ ★ ★ Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 355.9K Banking & Borrowing
  • 255K Reduce Debt & Boost Income
  • 456.2K Spending & Discounts
  • 248.4K Work, Benefits & Business
  • 606.2K Mortgages, Homes & Bills
  • 179.1K Life & Family
  • 264K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.2K Discuss & Feedback
  • 37.7K Read-Only Boards
Quick Search

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.