P Bath front panel large gap at bottom

steve1500

Whoever fitted the bath raised it too much so there is about a 1 inch gap between the floor and the bottom of panel
Any suggestions, on how to fill /cover the gap

TIA

bjorn_toby_wilde

UPVC trim comes in several different widths. If you remove the panel and fit a batten along the floor you can stick the UPVC trim to it then refit the panel. It will look neater and it’s waterproof.

grumpy_codger

bjorn_toby_wilde said:

.... If you remove the panel and fit a batten along the floor ...

With a 'P' bath this can be not as easy as just a batten.

bjorn_toby_wilde

grumpy_codger said:

bjorn_toby_wilde said:

.... If you remove the panel and fit a batten along the floor ...

With a 'P' bath this can be not as easy as just a batten.

It’s not as easy, but you cut short sections of batten and fasten them to the floor to follow the curve of the panel. The UPVC will bend.