We'd like to remind Forumites to please avoid political debate on the Forum... Read More »
We're aware that some users are experiencing technical issues which the team are working to resolve. See the Community Noticeboard for more info. Thank you for your patience.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Karcher K2 pressure washer
Options

PunkRoquefort
Posts: 101 Forumite

in Motoring
I have been given a K2 pressure washer and understand that as long as I use a low setting and use it from approx two feet away, it will be fine for washing a car.
However, I have a small stone chip mark, on the thin edge of my door, which I have painted/dabbed over.
Will this still be okay for the pressure washer?
However, I have a small stone chip mark, on the thin edge of my door, which I have painted/dabbed over.
Will this still be okay for the pressure washer?
0
Comments
-
Yes0
-
..should be fine as long as you keep the nozzle at that sort of distance......"It's everybody's fault but mine...."0
-
& you are not in a hosepipe ban area 🤣Life in the slow lane0
-
Many Karcher pressure washers come with two lances, do not use the one with the larger end, that has a rotating spray, on a car… they are too aggressive.
A soft nylon brush and soapy water will shift dirt better than trying to blast it off with a pressure washer, the latter will be fine to rinse off.0 -
You can get a hose to use from a water butt or large bucket, ( a trug type bucket) this is what I use when washing my car with my pressure washer, they’re perfectly fine for washing cars, with the correct nozzle as already mentioned…0
-
I just use the hose pipe. After a couple of goes, the novelty of getting out the pressure washer and an extension lead turns to a massive chore- well putting it away again certainly does!I bought one of those eBay hosepipe snow foam guns, not as good as the one on the pressure washer, but no trouble to get out and put away.A good layer of foam and a few minutes to soak into the chem-trail residue and bird pooh and I rinse it off with the hose, to reveal the car looking exactly the same as before, but now wet.Then I drop a shampoo stick* into my trusty old Karcher "scratch-o-matic" car wash brush (one with hosepipe fittings not pressure washer ones), attach to the hose and scrub a few lines into the "paint", then a final rinse off with the hose and it is done.Then I just put the brush & tools away,wind the hosepipe back in and leave the car to dry streaky but clean.*contrary to popular belief, printer ink is not the most expensive substance in the World, shampoo sticks are. I paid 50p for 20 last time I bought any (Fletcher's in Birmingham), now they are £12 for 20, Halfords poverty range are £8 for 20- 40p each!!!!!I want to go back to The Olden Days, when every single thing that I can think of was better.....
(except air quality and Medical Science)
0 -
I’ve used the “dirt blaster” rotating nozzle at close range on my car to remove pigeon crap without issue. Unless your paint is already damaged it shouldn’t be a problem. Just need to be careful around any paint protection film or decals as it will lift them at the edges.0
-
born_again said:& you are not in a hosepipe ban area 🤣
Easy, just say that your hosepipe identifies as a watering can.0
Confirm your email address to Create Threads and Reply

Categories
- All Categories
- 351K Banking & Borrowing
- 253.1K Reduce Debt & Boost Income
- 453.6K Spending & Discounts
- 244K Work, Benefits & Business
- 598.9K Mortgages, Homes & Bills
- 176.9K Life & Family
- 257.3K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.1K Discuss & Feedback
- 37.6K Read-Only Boards