Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
We’d like to remind Forumites to please avoid political debate on the Forum.
This is to keep it a safe and useful space for MoneySaving discussions. Threads that are – or become – political in nature may be removed in line with the Forum’s rules. Thank you for your understanding.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Torque wrench for engine building
Hi
I'm replacing the clutch and refitting the gearbox and cylinder heads/barrels on my BMW motorcycle.
For the work, I need to torque bolts from 8.5Nm through to 125Nm (flywheel). The lower torque is for the oil pump cover.
I think I'm going to need two, maybe three wrenches with overlap in the torque range. Accuracy is important, especially for the flywheel bolts.
There's a lot of choice now with Chinese tools and there's a Uharbour set of three on Amazon which covers all that I need.
I don't really want to spend out on a Norbar or Snap-On and use would be very occasionally. Probably a one off for the clutch replacement.
Just wondering if anyone uses any of the cheaper torque wrenches.
Any help appreciated.
I'm replacing the clutch and refitting the gearbox and cylinder heads/barrels on my BMW motorcycle.
For the work, I need to torque bolts from 8.5Nm through to 125Nm (flywheel). The lower torque is for the oil pump cover.
I think I'm going to need two, maybe three wrenches with overlap in the torque range. Accuracy is important, especially for the flywheel bolts.
There's a lot of choice now with Chinese tools and there's a Uharbour set of three on Amazon which covers all that I need.
I don't really want to spend out on a Norbar or Snap-On and use would be very occasionally. Probably a one off for the clutch replacement.
Just wondering if anyone uses any of the cheaper torque wrenches.
Any help appreciated.
0
Comments
-
Got two Draper torque wrenches in my tool box that are likely 30 years old.
Maybe out of calibration but seem to work OK and give click at same settings as comparison.Signature on holiday for two weeks1 -
Ok thanks. I have an old Britool one that probably has never been recalibrated.Mutton_Geoff said:Got two Draper torque wrenches in my tool box that are likely 30 years old.
Maybe out of calibration but seem to work OK and give click at same settings as comparison.
The numbers are hard to read too.
Have ordered a couple of Uharbour torque wrenches anyway. They cover the ranges that I need.0
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards
