Xpelair front cover removal

Hi all, I was wondering if someone could help. I have two Xpelair ceiling fans (bathroom and kitchen) and one does not provide any airflow (just noise), while the other is working but very dusty. I would like to open them up to see whether some cleaning would help but I am unable to remove the front panels. I do not see any screws and I am afraid that they would just snap when forced. Any ideas on how to remove them?

Thank you very much.


Comments

  • molerat
    molerat Posts: 34,249 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    edited 5 January at 6:25PM
    The front baffle plate should just be clipped on and a good tug and fiddle should get it off.  There should be a little slot in one of the longer sides near the corner where you can push a screwdriver in to release the clip that holds the front on, swing the bottom out and push upwards slightly.

  • BoyJohn811
    BoyJohn811 Posts: 46 Forumite
    Third Anniversary 10 Posts
    Thank you very much, I will play around a bit, see if I manage to unclip the plate - hopefully, I will find the release clip. I just had a feeling that I was about the break them, so stopped.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.8K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 453K Spending & Discounts
  • 242.7K Work, Benefits & Business
  • 619.5K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.