We'd like to remind Forumites to please avoid political debate on the Forum... Read More »
We're aware that some users are experiencing technical issues which the team are working to resolve. See the Community Noticeboard for more info. Thank you for your patience.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Soundproofing Conservatory from Rain Noise?
Options
Comments
-
laurencewhymark said:Soot2006 said:I put some PVC sheeting under mine with some thick insulation boards between them and the roof itself, and it's made a big difference. The rain is hardly noticeable now.No man is worth crawling on this earth.
So much to read, so little time.0 -
LYM, are you ALSO wishing to improve the insulation/usability of the Connie?
If so, then look at the option of adding insulation to the underside of the roof.
Lots of options, but the simplest is almost certainly to just adhere the sheets to the existing joists - something like Stixall would do this job with ease. Cut the ~1" (you can go thicker if you want) Celotex-type insulation using a craft knife, landing the joints on the joists. Ideally run a thin bead of exp foam down the joining edges before fitting the next sheet, and press into place. Then foam seal around the perimeter, and foil-tape each joint.
Before doing this, remove any press-in foam strips from the bottoms and tops of each polycarb sheet (if fitted) to allow the area betwixt the poly and the new insulation to vent. If there isn't foam - if it's rubber, for example - then 'consider' drilling some vent holes instead, but this should be along the eaves end and under the polycarb so rain can't get in. I don't think there will be a cond issue anyway, as the void above the insulation will/should always be warmer that the outside temps as it'll have solar gain, and air shouldn't get to that void from inside the house either.
Then add a decorative layer to the underside. This could be as 'crude' as thick lining paper which is then emulsioned, or summat thicker like 'Walkrock' which is around 3mm thick? Or adhere lightweight (hollow plastic) cladding to it, in T&G style or whatevs.
A thought - you can get cheap and lightweight shower wall panels - I bet they'd work. Sparkly black... Hmmmm.0 -
You also have the option of leaving the odd polycarb panel exposed, if wanting some light.0
-
cajef said:We replaced our polycarbonate conservatory roof with a glass roof a few years ago it reduced the noise by about 80%, you can only hear very heavy rain and then it is not intrusive.
2 -
Silvertabby said:cajef said:We replaced our polycarbonate conservatory roof with a glass roof a few years ago it reduced the noise by about 80%, you can only hear very heavy rain and then it is not intrusive.1
-
Bendy_House said:Silvertabby said:cajef said:We replaced our polycarbonate conservatory roof with a glass roof a few years ago it reduced the noise by about 80%, you can only hear very heavy rain and then it is not intrusive.We like it, thanks!Easiest way to explain is that it is a Victorian style with glass roof. The wall nearest next door is brick from floor to roof, then we have a 3 pane bay window with a brick dwarf wall, then a brick pillar from floor to roof, then double patio doors, and, finally, another full height brick pillar. The floor is natural stone.It's east facing, so doesn't get horrendously hot in summer - and only only needs an oil filled radiator to keep it toasty in winter.
1 -
Silvertabby said:We like it, thanks!Easiest way to explain is that it is a Victorian style with glass roof. The wall nearest next door is brick from floor to roof, then we have a 3 pane bay window with a brick dwarf wall, then a brick pillar from floor to roof, then double patio doors, and, finally, another full height brick pillar. The floor is natural stone.It's east facing, so doesn't get horrendously hot in summer - and only only needs an oil filled radiator to keep it toasty in winter.Sounds even betterAnd the easiest way to explain it is...with a photo1
-
As Soot2006 and Bendy_House said insulation board covered with pvc sheets is a cheap way of reducing rain noise. I did this for my DD using white shower panels with a sparkle, it looks really good and was very easy to do. Her roof was a lean-to with wooden beams and triple wall plastic roof. I screwed extra battens at right angles to the beams and fixed the panels to them using the special clips provided.2
-
Bendy_House said:Silvertabby said:We like it, thanks!Easiest way to explain is that it is a Victorian style with glass roof. The wall nearest next door is brick from floor to roof, then we have a 3 pane bay window with a brick dwarf wall, then a brick pillar from floor to roof, then double patio doors, and, finally, another full height brick pillar. The floor is natural stone.It's east facing, so doesn't get horrendously hot in summer - and only only needs an oil filled radiator to keep it toasty in winter.Sounds even betterAnd the easiest way to explain it is...with a photo1
Confirm your email address to Create Threads and Reply

Categories
- All Categories
- 350.9K Banking & Borrowing
- 253.1K Reduce Debt & Boost Income
- 453.5K Spending & Discounts
- 243.9K Work, Benefits & Business
- 598.7K Mortgages, Homes & Bills
- 176.8K Life & Family
- 257.1K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.1K Discuss & Feedback
- 37.6K Read-Only Boards