Integrated washing machines

kenshaz

We have an indesit integrated washing machine in our fitted kitchen and it has gone on the blink ,will not spin and the dial keeps clicking around ,any advice .
If the worst happens and it is going to cost to much to repair and we replace .Are all integrated washers the same diameter and is there a method to remove them ie the adjuster legs at the bottom .
Regards Ken

dld2s

Have you checked the filter, my integrated machine wasn't spinning and basically coins etc had jammed the pump, also regards the machineclicking, have you tried switching off the machine at the socket for 5 or so minutes, the reason I say this is, although not the same problem my machine went haywire just clicking and the dial going round and round, I switched it off at the socket and left it a while and when I switched it on it was fine.

regards size, sorry don't know if you get different sizes, but what I would do is measure my machine and go for something the same size

kwatt

Hi Ken,

When the dial spins and you get flashes on and Indesit or Hotpoint, count the flashes as that gives you the fault code. It means it has a board with what's known as EVO2 software/firmware on it.

Once you know that post here and I may be able to help you find what the cause is, or at least point you in the right direction. Or post the error on https://www.ukwhitegoods.co.uk as I'm offline from lunch tomorrow for a day so I may be unable to answer quickly.

HTH

Regards

K.