Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Netgear USB control center
Gavin78
Posts: 266
Forumite
in Techie Stuff
I've recently purchased a Netgear 6400 V2 router. I've connected the printer to the router and used the Netgear USB control center to power the printer.
However the computer wont go into sleep mode since install, even changing the power options in windows 10 doesn't do anything
As a last resort I did a clean install and just installed the control center again and it's doing the same thing. the monitor goes off but the computer won't sleep and is still running but hitting the keyboard and mouse does not wake the monitor. I have to do a hard reset.
Anyone else know about this problem?
However the computer wont go into sleep mode since install, even changing the power options in windows 10 doesn't do anything
As a last resort I did a clean install and just installed the control center again and it's doing the same thing. the monitor goes off but the computer won't sleep and is still running but hitting the keyboard and mouse does not wake the monitor. I have to do a hard reset.
Anyone else know about this problem?
0
Comments
-
No, but does the router allow the printer to be shown as a LPT or similar TCP port network printer. Sharing USB over network hmmm check the virtual USB port in device manager and check that the PC is allowed to turn off/sleep the device, guessing on this of course4.8kWp 12x400W Longhi 9.6 kWh battery Giv-hy 5.0 Inverter, WSW facing Essex . Aint no sunshine ☀️ Octopus gas fixed 5.07 + Octopus Intelligent Flux leccy
CEC Email energyclub@moneysavingexpert.com0 -
I checked the router settings and there is a choice under VPN which default was UDP so I changed it to TCP and it was saying in the control center that it was waiting for the printer to connect to I ended up switich back to UDP.
Will check V, ports if I can find them0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards
