Free shed plans wanted please

I am looking for free downloadable plans, amount and size of material required and instructions to build a garden shed about 8x6 or 10x8

I have found a very old post but some of the threads are so old they no longer exist.

New sheds are flimsy and expensive. I haven't found a comprehensive book and Free plan searches usually lead to sites that are not free or requiring you to register, with all the scams about I am too worried to do this

Any help would be appreciated

Comments

  • EssexExile
    EssexExile Posts: 6,424 Forumite
    Tenth Anniversary 1,000 Posts Name Dropper Photogenic
    Find a shed you like, take lots of measurements & photos. Copy it.
    Tall, dark & handsome. Well two out of three ain't bad.
  • EachPenny
    EachPenny Posts: 12,239 Forumite
    10,000 Posts Combo Breaker
    New sheds are flimsy and expensive.
    Timber is very expensive, especially for the amount you'll need to build a shed.

    My approach would be to buy a shed and add extra timber into it to strengthen. I did this for a friend and a 4'x6' shed that cost about £200 needed an extra £100 of wood.

    The key thing to add is diagonal bracing as most sheds don't have this - hence after a few years they start to go wonky.

    A purchased shed will usually come with a 9mm chipboard floor. I'd change that to an 18mm OSB floor and use the 9mm chipboard supplied as bracing instead (cut into strips approx 100mm wide). Likewise for the roof - add a piece of wood running the length of the shed to support the ridge.
    "In the future, everyone will be rich for 15 minutes"
  • Thank you for your suggestions,

    I have a plan from a previous link that helps.
    I also registered with a free recycle website and low and behold someone has one free. Just need a man to help me!
    If anyone has plans please let me know
  • gamston
    gamston Posts: 693 Forumite
    Part of the Furniture 500 Posts
    as said sheds are not cheap to make,
    I've made 2 for myself, one standard 12 X 8, the other built to fit into a corner I've got
    think they cost around £800 mark
    made from 4x2 posts, 19mm loglap, plywood roof covered with EDPM rubber and trimmed with their trim (so it lasts and looks good
    windows & doors are UPVC off ebay
    Loglap from ebay, place near Doncaster (think it was westwoodside) they delivery all over the country
    if the corners are square its easy enough to design, if its an odd shape you will need to trim the corner post so its square each each way
    also think about posts for shelfing
    I built both of my ones on hardcore concrete base with 1 level of brick course (bricks turned on their sides so they stand long edge ), resting the posts on the bricks with the lowest loglap overlapping the brick course so the loglap allows the rain water to roll off and drop to the ground
  • gamston
    gamston Posts: 693 Forumite
    Part of the Furniture 500 Posts
    another thing
    on the corners I put a strip of 20mm thick X 44 mm wide timber (over lapping the post by 20 mm then run the loglap both side) up to the etcedges of these timber strips gives a good finish on the corner and protects the ends of the loglap being brashed by my mower handles or wheelborrow
  • EachPenny wrote: »
    Timber is very expensive, especially for the amount you'll need to build a shed.

    My approach would be to buy a shed and add extra timber into it to strengthen. I did this for a friend and a 4'x6' shed that cost about £200 needed an extra £100 of wood.

    The key thing to add is diagonal bracing as most sheds don't have this - hence after a few years they start to go wonky.

    A purchased shed will usually come with a 9mm chipboard floor. I'd change that to an 18mm OSB floor and use the 9mm chipboard supplied as bracing instead (cut into strips approx 100mm wide). Likewise for the roof - add a piece of wood running the length of the shed to support the ridge.



    Thank very much we do intend to use your knowledge thank you
  • gamston
    gamston Posts: 693 Forumite
    Part of the Furniture 500 Posts
    there are lots of places that sell secondhand timber or building sites that will sell the wood/shuttering boards when they finish the job
    maybe worth looking, every if only for strengthening or for the shelfing
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350.3K Banking & Borrowing
  • 252.9K Reduce Debt & Boost Income
  • 453.2K Spending & Discounts
  • 243.3K Work, Benefits & Business
  • 597.9K Mortgages, Homes & Bills
  • 176.6K Life & Family
  • 256.4K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.