How do I connect this 40mm (ish) chrome push fit waste to existing 32mm sink waste?

Hi all

In her wisdom, my wife recently went shopping for a few grocery items and returned with a new cloakroom toilet set. I now have the task of fitting this new bathroom suite if I value my Friday nights out with the lads. So, after I ripped out the old sink I discovered that the waste for that old sink has 32mm Hepworth written on the pipe. I’d like to keep this pipe in place because it fits snugly behind the skirting and also the exit hole to the grid outside is the perfect size. So, Iuinboxed all the new items and I have found that the new sink Waste (Chrome push thingy) is a different size to the 32mm Waste pipe. The Chrome sink waste appears to be 40mm (ish) and is threaded at the bottom. So, I assume I need to buy a ‘U’ bend that somehow will screw into the bottom of the Chrome waste but how (and where in the chain do I get from 40mm (ish) Chrome Waste down to 32mm pipe? Is there a ‘U’ bend that is 40mm (ish) at the top but has an exit size of 32mm? Or do I reduce elsewhere?

Thanks all.

Comments

This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.8K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 453K Spending & Discounts
  • 242.7K Work, Benefits & Business
  • 619.5K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.6K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.