Virgin Superhub 3 - change internal IP range

martyp

Hi all,
Just had a Superhub 3 installed as my 2ac failed and have the same problem where the default IP range is 192.168.0.x and my devices are configured as 192.168.1.x but can't change it. Tried the method someone found here:
https://community.virginmedia.com/t5/QuickStart-set-up-and/Superhub-3-internal-network-address/m-p/3600047/highlight/false#M93709

Although can't get online or get an IP address after doing so, seems like DHCP might not be working.

Based on later comments suggesting the latest firmware has broken this I guess I'll have to get a router and use it in modem mode - any suggestions for anything cheap (ideally under £40) that would work well?

onomatopoeia99

Just a word of warning - If you have a static IP address, you can't do that. VM set up static addresses by building a GRE tunnel (rather than something sensible, like DHCPing it down from their end) which doesn't happen with the "superhub" in modem only mode so the router ends up with a dynamic WAN address. It means you can't use a different router.

If you don't pay for a static IP, then that's not a problem.

martyp

Cool, thanks. I'm not using a static IP but useful to know.
Interestingly, people reported not being able to access the admin page but I enabled remote management and could access it externally using my phone using [url]https://xx.xx.xx.xx:xxxx[/url] on there I saw the DHCP was still on 192.168.0.x yet devices with 192.168.1.x IPs had connected ok.