bathroom advice, identify shower head and bath seal help.

chezybezy

Hi all, everyone had a good Christmas?
I hoping you can help, I'm finally getting around to doing those little bits that you put off finishing off in your bathroom.

ideally i would like a slightly longer shower hose but would this affect my water pressure / shower flow rate if i do?

Identify Shower Head. can anyone help identify who makes this? IIRC was purchased from QVC many years ago. I have tired other heads for poor water pressure / flow showers and nothing comes close to how this works! (hence why its in a sorry state from keeping it for so long) i think it does something inside as when you turn the 'tap' on it takes a moment to then come out. i do not think it was actually designed for a poor shower / water and we just tried it on the off chance.


Bath panel / edge seal. The panel needed replacing, we went with a lovely style however it appears to be bowing slightly where the seal is not intact (i believe its due to its material). Any suggestions? as it is not easy to rerun the sealant along this edge, and if i leave it any longer ill have to pay for a new one and someone to fit it again.

Pics below, apologises for the odd colouring unsure why my phone has done that!

Shower Head:
ShowerHead1
ShowerHead2
ShowerHead3
ShowerHead4

Bath Side:
BathSide1
BathSide2

southcoastrgi

The only pic that works is bathside 2 the album appears to be private which is maybe why nothing shows

chezybezy

southcoastrgi wrote: »

The only pic that works is bathside 2 the album appears to be private which is maybe why nothing shows

Thanks for letting me know, turns out I had a space and a carage return at the end of my url links, I didn't notice when I edited the links to make them look neater. Sorry!

The links should be working now.

chezybezy

small bump.

Le_Kirk

A slightly longer shower hose shouldn't be a problem. Shower looks like a Mira but which model I don't know. Best bet it to take it into a place like Screwfix or plumb centre and ask. Also you will need to tell them your water supply, is it from hot water cylinder or combi boiler.

Bath panel looks like it is slightly too long for the space and is bowing outwards. If that is not the case, then maybe it just needs a strengthening batten on the inside.