Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
sony Mp3 / netgear wireless compatibilty problems
garyw73
Posts: 52 Forumite
in Techie Stuff
Can someone help sort out a litlle problem.
i have a sony nw-e002 mp3 player and a netgear WPN111 router - everytime i plug the mp3 player into the pc, the next time i log on i cannot get a connection to the netwrok or the internet.
does anyone know of a patch / firmware download etc that might solve the problem??
Ta.
i have a sony nw-e002 mp3 player and a netgear WPN111 router - everytime i plug the mp3 player into the pc, the next time i log on i cannot get a connection to the netwrok or the internet.
does anyone know of a patch / firmware download etc that might solve the problem??
Ta.
0
Comments
-
I suspect you need to remember to click on the "safely remove hardware" icon on the bottom right of your screen and highlight "mass storage device" and then stop , before unplugging the MP3 player (it's a small green arror with a small grey box underneath)
this should top the wireless problemEx forum ambassador
Long term forum member0 -
It could be a power issue USB ports work in pairs each pair can provide 500mA now if your mp3 player uses 260mA and the usb wireless adaptor uses 260mA then when you have them both connected to the same usb root hub (pair of usb ports) then 1 of them wont work.
You can use device manager to see what each device is useing, go to the bottom of the list and double click each of the USB root Hub's and click the power tab I find that mass storage devices (your mp3 player tend to use the full 500mA, my usb wireless mouse on my laptop uses 100mA and my finger print reader uses 260mA so I keep the finger print reader and the mouse receiver in the same pair and the hard drive goes in another port and the 2nd port doesnt get used.
By unplugging and rechecking the usb root hub power pages you will be able to work out which ports work together and use your ports to their fullest.0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.1K Mortgages, Homes & Bills
- 179.1K Life & Family
- 263.9K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards
