Settle an argument

Chanes

If you replace failed double glazed (french door) window glass they must have a FENSA certificate - as well as being toughened.

Or does FENSA apply only to an entire window and frame replacement?

SmlSave

The glass will need a FENSA Certificate or a Building Regulation Certificate as far as I'm aware.

It's not unusual though to 'forget' until asked when selling the property and then to get a retrospective certificate or an indemnity policy though

fed_up_and_stressed

Chanes wrote: »

If you replace failed double glazed (french door) window glass they must have a FENSA certificate - as well as being toughened.

Or does FENSA apply only to an entire window and frame replacement?

No repairs e.g replacement glass are not notifyable to Fensa themselves, but Fensa suggest in their FAQ's contacting your area building control before commencing work.

Chanes

I can buy compliant panels and fit them myself which saves a lot over getting a company to do such a simple job. Thanks for the swift replies.

I was wrong I thought the glass had to officially certified by a FENSA fitter.

StumpyPumpy

From www.fensa.co.uk

What has to be certified?
Where a window or windows is/are completely replaced (as opposed to repaired) in existing dwellings, they must comply with Approved Documents Parts L1B and K4 (England) or N (Wales) (safety in relation to impact). In addition, the building should not end up with a worse level of compliance with respect to other applicable parts of the Building Regulations, which includes Parts A (Structure), B (means of escape in case of fire), C (Moisture Penetration, F (ventilation), J (combustion appliances and fuel storage systems), M (access for the disabled) and Regulation 7 (Workmanship and Materials).

The Building Regulations for replacement windows state that "The situation must be made no worse than the outgoing windows". For example if the outgoing windows contained trickle vents the new placement windows must include them.

Windows and doors in critical locations ie windows below 800mm from floor level and doors where the glass comes within 1500mm of the floor level to the start of the glass must contain safety glass (toughened or laminated) and must include the relevant safety mark clearly visible to comply with Approved Document N.

Compliance with the Gas Safety (Installation and Use) Regulations 1998 is also essential.

FENSA does not apply to conservatories, porches, commercial premises or new build properties or extensions. In all of these instances you are required to go through the Local Authority Building Control process. If your property is a flat then planning permission may be required before replacing your windows, therefore it is advisable to check this with the Planning Department of your Local Authority. If planning permission is required a FENSA registered company can register the installation for certification purposes. If you live in a property that is a Listed Building and wish to replace your windows this would fall under the jurisdiction of the relevant Local Authority therefore planning permission would be required and the installation cannot be registered with FENSA.

Doors with less than 50% glazing do not require registration.

FENSA also does not apply to caravans or holiday chalets.

Grovey1

you do not need fensa or building control certificate to change glass. you only need it for a complete change of the upvc frame.





you would need to know what glass you are replacing i.e toughend glass or low e glass when was the French doors fitted if it was before 2002 then chances are they are clear toughend if it was after they should be low e (energy rated) hope this helps.