We'd like to remind Forumites to please avoid political debate on the Forum... Read More »
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Hot water in bath tap a slow trickle
Options
suziqqq
Posts: 293 Forumite
we have just installed a new bath and taps. The tap is for low pressure systems minimum 0.3 bar but the hot water is only coming out at a trickle its driving us mad any ideas what is the problem thanks
If i knew the answers to all the questions i wouldn't be on here 
0
Comments
-
Possible airlock if you drained down the water. Did you use flexi-tap connectors for the new taps? If so they could be kinked.0
-
no never drained system pipes have isolator valves yes have flex hoses will check themIf i knew the answers to all the questions i wouldn't be on here0
-
Is the isolator fully opened?Eat vegetables and fear no creditors, rather than eat duck and hide.0
-
look at the size of the hole in a 22mm flexi, link here, then you will know why the flow isn't very good, if you change the iso to a full bore one, link here, it might make it better,
plus the flexi's must be wras approved for hot & cold suppliesI'm only here while I wait for Corrie to start.
You get no BS from me & if I think you are wrong I WILL tell you.0 -
We have the same pipes and isolatord as before have only changed the taps it was ok before we did thatIf i knew the answers to all the questions i wouldn't be on here0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 351.2K Banking & Borrowing
- 253.2K Reduce Debt & Boost Income
- 453.7K Spending & Discounts
- 244.1K Work, Benefits & Business
- 599.2K Mortgages, Homes & Bills
- 177K Life & Family
- 257.5K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.1K Discuss & Feedback
- 37.6K Read-Only Boards