Making good holes drilled into ceramic bathroom tiles

I had an abortive attempt to put up a shower screen on my bath and it leaked like a sieve. I've given up on it and put up a shower curtain. I want to take the screen down (scraping the silicone sealant from the bathroom tiles will be fun :() but I'm not sure how to fill in and make waterproof the holes that I drilled into the bathroom tiles to hang the shower screen.

What does the forum reckon? Silicone sealant, grout or something else?

Any help/info/advice would be much appreciated.
Trying hard to be a good moneysaver.

Comments

  • ozskin
    ozskin Posts: 451 Forumite
    fill with silicone
  • Mr_Warren_2
    Mr_Warren_2 Posts: 991 Forumite
    Part of the Furniture 500 Posts Combo Breaker
    ...Or same waterproof grout used on tiles.
  • sandy2_2
    sandy2_2 Posts: 1,931 Forumite
    Depending on the colour of the tiles I'd fill the hole with grout/silicone whatever then pop one of those little cap thingies over the top, you know the things that you get with flat pack furniture to cover the screws. If the tiles are coloured, I might then blend a tiny bit of paint to paint over.
  • greyteam1959
    greyteam1959 Posts: 4,691 Forumite
    Part of the Furniture 1,000 Posts Name Dropper
    For something a bit 'fancy'.....
    Go to a glaziers and have a look at some mirror screws....
    They are a slot head screw with a thread in that you can screw a fancy cover into.............
    These are just plain dome ones but you can get a different sorts and designs

    http://www.diytools.co.uk/diy/Main/Category.asp?iCategoryID=971
    Put a bit of silicone in the hole to seal it then use these
    :D
  • Silicone isn't really required, a grout will do the job. Pop down to Topps tiles, who have a range of coloured grouts, one of which should match the colour of your tiles. Silicone is going to be white, ivory, clear or brown, and could stand out like a sore thumb.

    You need to mix a tiny amount of grout (a palm full should do the job) with a tiny amount of water so its forms a firm paste, force it into the holes with a knife and wipe with a fairly dry sponge until smooth. Don't use the shower for a full 24 hours to ensure the grout is fully dry.

    As for getting the old silicone off, scrape what you can off, then get some 'silicone eater' from a DIY store. It does eactly what it says on the tin. This is the stuff: http://www.tradetiler.com/acatalog/siliconing_tiles.html

    For future reference, I always tell people to hold on to a spare few tiles just in case anything like this creeps up in the future = easily replaced.
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.8K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 453K Spending & Discounts
  • 242.8K Work, Benefits & Business
  • 619.6K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.