DIY kitchen fit - built in appliances

ey_up

Daft question but I am diy'ing the kitchen (with some help from a joiner) and am having a integrated dish washer, fridge and freezer. I have 3x 600 (596) appliance facias coming but what size gap do I actually leave between the normal kitchen units. I suppose nearer to 600 the better to make the door gaps match those of the cupboards but will this cause difficulties getting the things in and out?

Is there a standard width to use? 605mm?

Cheers

jennifernil

You would normally leave exactly 600mm for an integrated appliance.

Example here.....look at the drawings of the dimensions

http://www.bosch-home.co.uk/our-products/dishwashers/fullsize-dishwashers/dishwasher-range/SMI53E05GB.html?source=browse

and the "installation guide", found under the "additional documents" tab.

ey_up

top diagram on that link. thank you.just what I needed.

keystone

Are these appliances built in or are they integrated? Your post says built in and J is talking integrated. Are you planning to have them all in a row because if you are then you will have to have some additional worktop support between them.

Cheers

ey_up

editted original post to clarify that's keystone.. integrated is way we going. they will not be in one row but dotted around between cabinets so no additional support required. cheers

keystone

OK thanks. 600mm spaces then as advised by another poster.

Cheers

ey_up

thanks key stone ans jenni much appreciated