Satinwood paint - water or solvent based?

Hi

Does anyone know which covers best or is there no difference?

Thank you,

Mart

Comments

  • vansboy
    vansboy Posts: 6,483 Forumite
    Part of the Furniture 1,000 Posts
    I've used the water based on all the wood in our place - using the water based quikdry primer, both from B&Q, own brand. I was put off by the Dulux being oil based, prefering the faster drying time & easier cleaning up.

    All the skirtings, doors & frames, were replaced, needed 2 coats primer & 4 coats satin, to get them looking good. I even lightly sanded, between coats!!

    Where we re-used 3 cupboard doors, I lost count of how many times I had to prime & coat & sand & re-do, to hide the stain which was previously applied.

    Result is FAR better than using gloss, as far as everyone that sees it says, anyway - so was worthwhile!!

    Proving pretty easy to keep clean, too!!

    VB
  • ormus
    ormus Posts: 42,714 Forumite
    ive used satinwood oil based paint many times. and i like it.
    both valspar and BQ own brand have been ok.

    ive used water based on new wood with good effect. im never too sure if its any good on old woodwork.
    Get some gorm.
  • Martyn_H
    Martyn_H Posts: 520 Forumite
    Part of the Furniture 100 Posts Name Dropper Combo Breaker
    Thank you for your replies. I'm a bit surprised that four coats of satinwood were needed, although don't beleive the claims made on the tins of the one coat type.
  • Oil based will yellow, the water based one's won't
  • misgrace
    misgrace Posts: 1,486 Forumite
    The thing is that we better start getting used to water based for woodwork, as we have only a couple years left to be able to buy oilbase.

    I hate waterbase paint for woodwork, as the finish with oilbase is far superior, and more hardwearing, okay, there is the drying the time, and the cleaning of your brushes in white spirit, and it does yellow quicker than waterbase.

    I will be buying up load of oil base near the deadline, as I cannot do a professional job without my oilbase.

    I do use it at times if for example I am going from dark mahogany stain doors to white, but I would always start with oilbase, then in between use the quick drying, then finish with a couple of coats of oilbase.

    Waterbase is not too bad on frames , but on a flush door, its not as nice finish as the oilbase.
  • kaya
    kaya Posts: 2,465 Forumite
    Part of the Furniture Combo Breaker
    ive got asthma, i painted my bedroom and slept in it 4 hours later with waterbased, oil based fumes are killers for asthmatics, and i dont have to buy white spirits to clean my brushes either, the less chemicals i use the better methinks
  • full-time-mum
    full-time-mum Posts: 1,962 Forumite
    We go for water based if at all possible - find it easier to work with AND definitely easier to clean up afterwards.
    7 Angel Bears for LovingHands Autumn Challenge. 10 KYSTGYSES. 3 and 3/4 (ran out of wool) small blanket/large square, 2 premie blankets, 2 Angel Claire Bodywarmers
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.8K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 453K Spending & Discounts
  • 242.8K Work, Benefits & Business
  • 619.5K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.