manual assessment at Jag/Land Rover

Astra_Turbo10

Dmac13 wrote: »

Awesome will ring on Monday to see what they say, like I said it's the weekend now and I only did the pre employment on Friday night at 6pm. Cheers for the help though

thanks mate

Astra_Turbo10

Dmac13 wrote: »

Yeh is for wolverhampton and I had my assessment 13th Jan and interview was 19th Jan. Relatively quick compared to some other users I've been reading!

Did you get a phone number when you got the invite for the pre employment thing mate? Or a contact email address? Thanks

Dmac13

Astra_Turbo10 wrote: »

Did you get a phone number when you got the invite for the pre employment thing mate? Or a contact email address? Thanks

07515325180 Stephanie that's what's on the email

lilalala

Every week 20 to 23 persons start so wait a little bit more and you're in

Fisherman1975

I had my assessment on 12th jan and interview was on 21st jan and I haven't heard anything since for Wolverhampton. I haven't had the email saying I have been successful or unsuccessful

noorkhanuk85

Me too. I had my assessment on the 1st February at Wolverhampton. I definitely passed but haven't heard from them yet about an interview.

Sam96

Got my manual assessment on Thursday, anybody else recently done one and could give me abit of info

Haych88

Manual assesmant for solihull or wolverhamton?

Haych88

Get part along with Jig make sure water bottle on top turn silver thing at end of part in to a U shape and place 4 long screws in to holes

Get the jig place it behind the part in engine bay so it don't move and put hook in the hole wid red tape.

Take break pedal and 4 nuts & extension bar in to car.

attach the four nuts to the screws coming out finger tight.

start with top right and work clockwise so top right bottom right bottom left .the top left you wont be abel to get to with finger so put it on the extension bar and then tighten it.

Return to table pick ratchet turn it on green side and tighten the bolts same order as above when you come to last screw top left use the extension bar attach it to ratchet then finish tightening.

Return tools to table And pick up seat place it in car from the same side you working on use the back door

Return table and pick magnets enter car from same side place magnets red blue green on to the spots in car with same colours click the sensors in and do push check on both to see if fitted (meaning click the cables in and then slightly try to pull apart to make sure there fitted and do not come apart)

get out car with seat go around enter seat in from opposite side remove magnets green blue red in reverse to what you put them on return to table and place magnets

Pick up last part and spanner start tightening outer nuts first finger tight then middle one then tighten all with spanner same order

Thats it basically it for solihull from what i remember and you don't have to finish it either long as you stick to the way they want you to

noorkhanuk85

Did anyone do their manual assessment at wolverhampton on the 1st feb?