resetting Humax pvr 9300T

pedrothefish

I had problem with Series Link on my Humax so I emailed Humax, had a reply back within 24hrs and it worked.
I thought i would share it.


• RE: "series link"‏
•
• Dear Customer,

Please note that the following steps will not delete recorded content,

Here is the full procedure for resetting the Humax Unit:

1. Power OFF the receiver (on / off button at the back of the Humax)
2. Disconnect the Aerial cable (Just the Arial cable)
3. Power On the receiver (with the Arial still disconnected)
4. Press MENU
5. Select Installation
6. Enter your password (default = 0000)
7. Select Default Setting
8. Select YES
9. Enter your password (Default = 0000)
10. When the receiver restarts, power off (turn the power off before automatic search)
11. Connect the Aerial Cable
12. Power ON - the receiver will then search for the channels.
13. Once channel search is finished a ‘Save’ option will become available,
14. Finished
Please note that once step 13 is finished and you save the results, please leave it on BBC1 for ten minutes and the guide will be fully populated.
Please note also that performing a default setting may change the screen ratio to 4:3 if this happens please try the following,
1. Menu,
2. Preferences,
3. AV control,
4. Press ok on screen ratio to change from 4:3 to 16:9 then press exit,

hope it helps someone

stormbite

I have been getting all sorts of grief from the OH about the series link problem. I hope this helps! Thanks

Norman_Castle

Thanks, Mine missed a few recordings. I nearly missed Wentworth. Luckily it was repeated on 5*. What will Bea do now?:eek:.
Not that I watch that rubbish.:)