Gas meter readings ft3 and m3

Hi

I'm looking at changing my tariff and have been browsing my last bill.
At present they have calculated my meter reading in cubic metres when my gas meter is actually measured in ft3.
Example: Gas usage - 126 (cubic metres) with a calorific value of 39.5 is worked out as 1414 KWH. Anyone get any info this?
Many Thanks

Comments

  • dogshome
    dogshome Posts: 3,878 Forumite
    Part of the Furniture 1,000 Posts Name Dropper
    Hmmm - On an Imperial ft3 meter where each unit delivers 100 cubic feet of gas, the Bill by a quite complex equation then adjusts it to cubic metres, and converts that to chargeable Kwh
    And just to make life difficult, each bills Kwh conversion.is slightly different according to the calorific quality of the gas.
    I puzzle over the 39.5 Calorific Quality on your bill, as I've seen a lot of Gas bills in my time and have never seen anythig higher than 32.1 - If you haven't made a typo it would be worth querying ths figure with your supplier.

    The quick check is to look at the bill and divide the Units used on the meter, into the Kwh charged
    If the answer is close to 31.5 you are being charged for an Imperial meter
    If the answer is close to 11.2 you are being charged for a Metric meter

    It's very bad financial news if you are being charged on the basis of a Metric meter, when it's actually Imperial
  • Cardew
    Cardew Posts: 29,056 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Rampant Recycler
    A gas unit on an Imperial Meter(i.e. yours) is 100 cubic feet. They divide this by 2.83 in the calculation to bring it down to cubic meters.

    So this means that if you have used 126 gas units(of 100 cubic feet) on your meter, you have used approx 4000kWh.
  • molerat
    molerat Posts: 34,261 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    dogshome wrote: »
    I puzzle over the 39.5 Calorific Quality on your bill, as I've seen a lot of Gas bills in my time and have never seen anythig higher than 32.1 -
    My bill this week was at 40.0
    From http://www.nationalgrid.com/uk/Gas/Data/misc/reports/description/
    Gas passing through the National Grid pipeline system has a CV of 37.5 MJ/m3 to 43.0 MJ/m3, with the exception of Stornoway which receives liquid petroleum gas.
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.8K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 453K Spending & Discounts
  • 242.8K Work, Benefits & Business
  • 619.6K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.