Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Power Cinema 3 - Can't get Radio to work
wackojackouk
Posts: 1,412
Forumite
in Techie Stuff
Hi guys
I got this software pre-installed on my PC at Xmas and after finally getting an FM Antennae cable from the suppliers (it wasn't in the box originally) I have started to use the program.
However I cannot get the radio to work. I have done a scan for channels but I can't hear ANY sound or anything.
I must be doing something wrong - can anyone advise me?
WJUK
I got this software pre-installed on my PC at Xmas and after finally getting an FM Antennae cable from the suppliers (it wasn't in the box originally) I have started to use the program.
However I cannot get the radio to work. I have done a scan for channels but I can't hear ANY sound or anything.
I must be doing something wrong - can anyone advise me?
WJUK
0
Comments
-
Hi I had power cinema built into my laptop when I brought it last summer,I could note get it to auto scan at all,so contacted medion/cyberlink they told me there was a fault with the software and sent me an updated version, might be worth a try!0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards