Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
DT92E thermostat
keith969
Posts: 1,575
Forumite
Anyone familiar with the Honeywell DT92E wireless room thermostat? According to the user guide, it is supposed to display the measured room temperature. However mine shows the temperature setpoint all the time. Is there any way of changing this? I'd like it to display the room temperature by default.
For every complex problem there is an answer that is clear, simple and wrong.
0
Comments
-
Might be worth checking the installation guide and checking 'installer mode' settings:
http://www.honeywelluk.com/Documents/Full-Install/pdf/1075.pdf
I did a similar thing for our wired Honeywell Thermostat in order to change a few settings
The Great Declutter Challenge - £876
0 -
I had a look, and there doesn't seem to be a way to change the displayed value in installer mode. BTW it is part of a Y9420H Sundial pack including the ST 9420C programmer.For every complex problem there is an answer that is clear, simple and wrong.0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.1K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards