Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Cavity wall installation -house built 2000
[Deleted User]
Posts: 0
Newbie
Apaprently, all houses built since 1992 have to have had it fitted.
However, a friend of mine has just had they're house done and that was after 1992.
My house was built in 2000 by Barratt cowboys, and we have a lot of problems with drafts etc.
I've heard you cant have cavity wall insulation redone but how do I tell if it has been done already?
However, a friend of mine has just had they're house done and that was after 1992.
My house was built in 2000 by Barratt cowboys, and we have a lot of problems with drafts etc.
I've heard you cant have cavity wall insulation redone but how do I tell if it has been done already?
0
Comments
-
Did they give you an 'as built' manual of information?
Where are the drafts coming from?Posts are not advice and must not be relied upon.0 -
It has never been a requirement, and still isn't. The designers have to achieve a heat loss figure - how they do it is up to them. You could get a cavity wall insulation survey done and see what they say, or you could drill a hole in the wall and have a look.
Chances are it was designed right, but not built right and I would be looking at plasterboard walls, anything that penetrates the inner leaf - pipes, cables, joists etc. and general fit of doors and windows for starters.
HTH Brian,0 -
It has never been a requirement, and still isn't. The designers have to achieve a heat loss figure - how they do it is up to them. You could get a cavity wall insulation survey done and see what they say, or you could drill a hole in the wall and have a look.
Chances are it was designed right, but not built right and I would be looking at plasterboard walls, anything that penetrates the inner leaf - pipes, cables, joists etc. and general fit of doors and windows for starters.
HTH Brian,
And Barratt (the housebuilder) are complete cowboys !0 -
Funnily enough had someone from Mark Group knock on the door last night.
They drilled into the wall and had a look (and showed me). No cavity wall insulation....
Anyway, signed up with them now. Cheers Barratt..0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards