Fixing glass lampshade - what glue?

I have a beautiful lamp, shaped like a snowdrop, so the shade and bulb point down.

The glass shade has pulled away from its metal and is threatening to fall off and break. OH has glued it with Superglue a couple of time, but the repair doesn't last more than a couple of months.

I'd be very grateful if anyone can recommend glue that really does work.
Member #14 of SKI-ers club

Words, words, they're all we have to go by!.

(Pity they are mangled by this autocorrect!)

Comments

  • Ebe_Scrooge
    Ebe_Scrooge Posts: 7,320 Forumite
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    edited 21 February 2011 at 4:51PM
    I would think probably a 2-part epoxy glue would be best, something like Araldite. It comes in 2 tubes, you have to mix a small amount of hardener with the glue, which then starts the curing process. Just read the instructions on the pack. Available at any DIY store, and probably most supermarkets.

    I say Araldite, this is one of the old "original" 2-part glues that my dad always swore by, there are actually loads of different makes these days. Though dare I say it without being accused of advertising - the original and still the best :-)
  • pollypenny
    pollypenny Posts: 29,425 Forumite
    Part of the Furniture 10,000 Posts Name Dropper Photogenic
    Thank- you very much. I will get some this afternoon.

    Pol

    x
    Member #14 of SKI-ers club

    Words, words, they're all we have to go by!.

    (Pity they are mangled by this autocorrect!)
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 349.8K Banking & Borrowing
  • 252.6K Reduce Debt & Boost Income
  • 453K Spending & Discounts
  • 242.8K Work, Benefits & Business
  • 619.5K Mortgages, Homes & Bills
  • 176.4K Life & Family
  • 255.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 15.1K Coronavirus Support Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.