Status remote control programming

lyndytes

Hi
I have 3 status plug in sockets but ive lost the instructions on how to program the remote

Thanks

Chris55_2

Put the battery in the remote

Plug the receiver/socket in and turn on. The light will flash every second.
Press the On switch for the number you want to associate it with for 2 secs or until the light goes off.

That programs the socket to that number.

Repeat as necessary.

lyndytes

Chris55 wrote: »

Put the battery in the remote

Plug the receiver/socket in and turn on. The light will flash every second.
Press the On switch for the number you want to associate it with for 2 secs or until the light goes off.

That programs the socket to that number.

Repeat as necessary.

Hi Chris
I tried that but it won't work, the socket is flashing every 2/3 secs and the remote does not see the socket?

Chris55_2

Hmmm...

You should hold the On button on the remote control until the flashing light goes out. If that isn't happening then either the batteries have run down in the remote or it's broken!

You could try one of the other sockets just to check that it isn't one bad socket. Nothing could be interfering with the radio signal could it?

lyndytes

Chris55 wrote: »

Hmmm...

You should hold the On button on the remote control until the flashing light goes out. If that isn't happening then either the batteries have run down in the remote or it's broken!

You could try one of the other sockets just to check that it isn't one bad socket. Nothing could be interfering with the radio signal could it?

Sockets 1&2 work OK but No3 is just flashing (long flashes) and will not respond, is there any way of reseting the socket/remote

Thanks