📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

aqualisa quartz 10.5 shower temperature probs

2»

Comments

  • andyhop
    andyhop Posts: 1,996 Forumite
    Part of the Furniture 1,000 Posts Combo Breaker
    pinkteapot wrote: »
    We had 9.5kw showers installed (one in en-suite, one in bathroom, can't use both at the same time; downside of electric showers!). We can still get a comfortably warm shower out of them at the moment, even without the dial turned up full (just nearly full).

    Same as you - I like the fact they're not dependent on there being hot water in the tank. Due to low water pressure, it was that or normal showers with a pump but I was uncertain about noise from the pump.

    With either 9 or 9.5kw and higher (I can't remember which is the cut-off) you need thicker cabling than for lower power showers. Sparky should use 10mm cable to install it.

    Please tell me why you cant have 2 electric showers running at the same time in the same property? If you cant your installation is not to regs

    Cable thickness is not determined by shower KW only, Distance of cable, routing whether it be through insulated floors and ceilings ect
    Hi, we’ve had to remove your signature. If you’re not sure why please read the forum rules or email the forum team if you’re still unsure
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 350.6K Banking & Borrowing
  • 253K Reduce Debt & Boost Income
  • 453.3K Spending & Discounts
  • 243.6K Work, Benefits & Business
  • 598.3K Mortgages, Homes & Bills
  • 176.7K Life & Family
  • 256.7K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.