Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Toyoya Corolla 2004 - Worn out clutch (again!)
Comments
-
In what way has the new clutch failed, is it slipping, not actuating, what?Remember kids, it's the volts that jolt and the mills that kill.0
-
Could be the OPs driving. My grandad used to kill a clutch every year.0
-
Most premature clutch failures are down to poor driving skills, harsh, but true.
thats exactly what i thought first of all too.
Just because you have only done a few miles doesnt mean you may not have worn the clutch out. If you do mostly town driving you are on and off the clutch almost constantly which if you also have a habit of slipping the clutch could easily account for such rapid clutch wear.Cover me in honey and fling me to the hermaphrodites!0 -
spotting a faulty clutch is difficult if you dont know what your looking for here i will give you a few common pointers to look for on you removed clutch due to ill-fitted clutch.
the fingers on this pressure plate are bent
CAUSE- The pressure plate cover assembly was torqued down incorrectly i.e. not diagonally.
- The pressure plate cover assembly was torqued down with an air wrench.
shattered clutch disc
Clutch disc fitted incorrectly i.e. back to front
a worn pin on clutch disc doesnt really mean your at fault
CAUSE- Improper driving practice i.e. "dropping" the clutch whilst engine is turning at extremely high revolutions.
- Down changing of gears i.e. 5th gear to 2nd gear by a low speed/high driving gear method.
- Wear on the stop pins indicates the clutch plate has been wound past specified torque loading. This has the same affect on the springs.
- Misalignment.

- CAUSE Only clutch disc was replaced which caused a vacuum not allowing the clutch disc to separate from the clutch cover pressure plate assembly casting, when clutch is in disengaged position.
- SOLUTION Always replace clutch disc/clutch cover pressure plate assembly and clutch thrust release bearing when replacing clutch system.
0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 356K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.3K Spending & Discounts
- 248.5K Work, Benefits & Business
- 606.2K Mortgages, Homes & Bills
- 179.1K Life & Family
- 264K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards