📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

New glowplugs on berlingo

I've been having having starting problems on the bangernomics berlingo recently. It's the DW9 1.9 non turbo engine in a 2002 Berlingo van. I've put in a new, heavy duty battery but the problem's still here. It turns over and takes about 3 goes to get it going.

Next step, I'm going to put in new glow plugs. The plugs are obscured by a plastic inlet manifold. I think it's connected to an egr valve at one end and an oil breather pipe at the side. It doesn't look to hard to remove but I'm not sure if the manifold would have a gasket and if it would need to be replaced when doing this?

Any help appreciated. Failing this, I'll change the heater plug relay but hope this will work!

Comments

  • Hammyman
    Hammyman Posts: 9,913 Forumite
    Most cars with plastic manifolds have re-usable rubber gaskets.

    As regards the relay, TEST THIS BEFORE YOU CHANGE THE GLOWPLUGS. With a multimeter or test light/bulb connect the + probe to the wire going to the glowplugs and the other to the earth terminal on the battery. Get someone to turn the ignition key until the glowplug light comes on and check there's a good voltage there.
  • Thanks Hammyman, I'll test the plugs first then. Thanks for the help.
  • johnnyroper
    johnnyroper Posts: 1,592 Forumite
    Thanks Hammyman, I'll test the plugs first then. Thanks for the help.

    As above check output from timer relay first,when first turning on ignition expect to see 12volt at wire to glow plugs for approx 10 seconds on the DW9 engine.
    If thats ok i would take plugs out and test them on battery first just to be sure,get a wire with croc clips either end connect one end to battery pos terminal and the other to stud on glow plug then touch body of plug on to battery earth and see if they glow.

    as for manifold if memory serves correctly the outlets to alloy part of manifold have 'o' ring seals on so should be ok to reuse.
  • Thanks johnny. I'm having a go at it today. I've tested the circuit from the relay and got a fluctuating reading until it settled on 10.6 v after a few seconds.

    I'm struggling to get the manifold off to get at the plugs though!
This discussion has been closed.
★ ★ ★ Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 355.9K Banking & Borrowing
  • 255K Reduce Debt & Boost Income
  • 456.2K Spending & Discounts
  • 248.5K Work, Benefits & Business
  • 606.2K Mortgages, Homes & Bills
  • 179.1K Life & Family
  • 264K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.2K Discuss & Feedback
  • 37.7K Read-Only Boards
Quick Search

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.