📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Boxing in a pipe that suffers from condensation

Options
2»

Comments

  • Insulate it. Boxing it? Nah.. won't work.


    Isulating & boxing it in would work together. So long as where the pipe enters & exits is sound.
    Not Again
  • keystone
    keystone Posts: 10,916 Forumite
    The pipe will be close to freezing as it goes through the house. Its not a case of humidity, its a case of temperature difference on this one.
    Yes exactly - water vapour condensing on a cold surface. I tried to suggest (perhaps incompetantly) that minimising the water vapour (humidity) will reduce the condensation. I didn't mean it will eradicate it.

    Cheers
    The difference between genius and stupidity is that genius has it's limits. - Einstein
  • Insulating the pipe should help.

    Had condensation from a cold water mains pipe in our downstairs toilet a few years ago and once I insulated it and boxed it in it was fine.

    EDIT - Used the same insulation that iamcornholio mentioned in their post.
  • keystone wrote: »
    Yes exactly - water vapour condensing on a cold surface. I tried to suggest (perhaps incompetantly) that minimising the water vapour (humidity) will reduce the condensation. I didn't mean it will eradicate it.

    Cheers


    I know what you are saying but it wouldn't solve the problem.

    I get it under my sink in my kitchen unit. No water there. The house is as dry as you like but it happens to be the incoming mains & the coldest place in the house. Now me fitting an extractor in the kitchen to remove the water vapour would work but the most benefit would come from the extractor dropping the air temperature so its closer to the pipe temperature so less condensation would occur.

    Hence to say it gets a bit of lagging, that is it. I like my house warm....
    Not Again
  • keystone
    keystone Posts: 10,916 Forumite
    I know what you are saying but it wouldn't solve the problem.
    I agree but we don't know that as its a utility room in an old barn that the air isn't wringing wet most of the time anyway. Personally I'd be looking to reroute the waste pipe if at all possible.

    Cheers
    The difference between genius and stupidity is that genius has it's limits. - Einstein
  • iamcornholio
    iamcornholio Posts: 1,900 Forumite
    keystone wrote: »
    and get wet insulation?

    Cheers

    No ... not unless the pipe leaks :p

    The insualtion will act as a barrier so that no air will hit the cold pipe, and therefore no air will condense on the cold pipe and give up the moisture otherwise held in suspension. Air will not condense on the insualtion

    The simplist solution is to insulate the pipe and then box it in as proposed. Job done
  • diable
    diable Posts: 5,258 Forumite
    Yes, or the proper stuff from somewhere like wickes

    I think the pipe is a waste pipe so would be larger then 22mm.
  • maninthestreet
    maninthestreet Posts: 16,127 Forumite
    Part of the Furniture
    Buy some of this stuff:

    http://www.diy.com/diy/jsp/bq/nav.jsp?action=detail&fh_secondid=10617653&ecamp=trf-005&CAWELAID=408161277

    Wrap it round the pipe, hold in place with sellotape or maybe plastic ties.
    "You were only supposed to blow the bl**dy doors off!!"
This discussion has been closed.
Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 351.1K Banking & Borrowing
  • 253.1K Reduce Debt & Boost Income
  • 453.6K Spending & Discounts
  • 244.1K Work, Benefits & Business
  • 599K Mortgages, Homes & Bills
  • 177K Life & Family
  • 257.4K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.1K Discuss & Feedback
  • 37.6K Read-Only Boards

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.