📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!

Running off mains - should I take battery out?

2»

Comments

  • Lil306
    Lil306 Posts: 1,692
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    Forumite
    Just to remind you, mains failure lost work. Pull out power lead just the same, you can also corrupt the PC hard drive. Your laptop, leave the battery alone and buy another when required.
    That defies the point of using a battery, the issue isn't with the battery being faulty it just needs calibrating again to last longer
    Owner of andrewhope.co.uk, hate cars and love them

    Working towards DFD

    HSBC Credit Card - £2700 / £7500
    AA Loans - (cleared £9700)
  • totalsolutions
    totalsolutions Posts: 3,110 Forumite
    Enter BIOS and look for "recalibration" of the battery then. Sometimes its in there. It will test and deplete the charge then recharge. I said leaving the battery out leaves you open to lost work when the power goes off accidentally.
  • thescouselander
    thescouselander Posts: 5,547
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    Forumite
    Yes, using the mains all the time will make the battery degrade. The best thing for the battery is to use it - don't discharge it too far either so use it down to no more than 30% remaining before recharging. If you aren't going to use the computer for a while store it with the battery at 50% charge. Try to not let the battery sit at 100% charge for too long especially when it is hot.

    Probably the best thing to do it to use the battery every day before going back to the mains - start recharging when you get down to about 50% charge.

    The computer I am using now is 2 years old and the battery is still at 96% and has completed hundreds of cycles using these techniques.
  • Bogof_Babe
    Bogof_Babe Posts: 10,803 Forumite
    Oh dear, more confusing advice. I'm not sure what is meant by BIOS so if anyone could explain that I'd be grateful.

    Switched on this morning to find battery 100%, so immediately unplugged from mains, which was about half an hour ago. Battery now showing 89% remaining i.e. 2.45 hours, which is a bit disconcerting as yesterday when it was fully charged it showed 4.5 hours life. Hope I haven't nakkered it already.

    So when it runs down to nothing today, I should put it on the charger until it's full again then take it out of the machine and work on mains until when? Oh dear this is so confusing :o. I could really do with staying online while it recharges, but I think this is a no-no?

    It doesn't help that tomorrow I'm going away for a week and won't be taking it with me :(.
    :D I haven't bogged off yet, and I ain't no babe :D

  • Bogof_Babe wrote: »
    Oh dear, more confusing advice. I'm not sure what is meant by BIOS so if anyone could explain that I'd be grateful.

    Switched on this morning to find battery 100%, so immediately unplugged from mains, which was about half an hour ago. Battery now showing 89% remaining i.e. 2.45 hours, which is a bit disconcerting as yesterday when it was fully charged it showed 4.5 hours life. Hope I haven't nakkered it already.

    So when it runs down to nothing today, I should put it on the charger until it's full again then take it out of the machine and work on mains until when? Oh dear this is so confusing :o. I could really do with staying online while it recharges, but I think this is a no-no?

    It doesn't help that tomorrow I'm going away for a week and won't be taking it with me :(.

    Dont run it down to nothing - its bad for the battery. Run it to about 50% and then charge.

    Also the amount of time your battery lasts will depend on how hard your computer is working. Eg, looking at websites that contain a lot of flash animation causes a higher load on the processor and so the battery will run down faster.
  • Lil306
    Lil306 Posts: 1,692
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    Forumite
    edited 15 July 2010 at 12:51PM
    Dont run it down to nothing - its bad for the battery. Run it to about 50% and then charge.

    Also the amount of time your battery lasts will depend on how hard your computer is working. Eg, looking at websites that contain a lot of flash animation causes a higher load on the processor and so the battery will run down faster.

    To properly calibrate a battery it should be fully discharged, recharged, then discharged again. Which means running on batteries until the laptop loses all power and shuts off completely. If you run it to 50% only, then the battery loses it's memory and effectively think it's life cycle is the remaining 50%. Thats why you have to let them shutdown completely, this then makes the battery do a full recharge cycle and another full discharge to learn it's life cycle.

    After that it can be plugged into mains and can be used as normal

    When it's calibrated in BIOS, you normally press something like F1/F2 or Del for BIOS, there may be a power section. Then battery calibration
    Owner of andrewhope.co.uk, hate cars and love them

    Working towards DFD

    HSBC Credit Card - £2700 / £7500
    AA Loans - (cleared £9700)
  • Bogof_Babe
    Bogof_Babe Posts: 10,803 Forumite
    Right, well in the light of what seems like a bit of conflicting advice I'm going for the middle ground :D. I let it run down to 18% (incidentally it revised its time remaining upwards to 3.5 hours even though it initally said 2.5) and have just now plugged it back in.

    It can have a nice rest for a week after today. I'll probably unplug it from the mains while I'm away then see what it's up to when I get back. (I'll be online next week but not on this machine).

    Just been converting all my household spreadsheets from Microsoft Works to Excel - that was fun!
    :D I haven't bogged off yet, and I ain't no babe :D

  • Lil306
    Lil306 Posts: 1,692
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    Forumite
    Bogof_Babe wrote: »
    Right, well in the light of what seems like a bit of conflicting advice I'm going for the middle ground :D. I let it run down to 18% (incidentally it revised its time remaining upwards to 3.5 hours even though it initally said 2.5) and have just now plugged it back in.

    It can have a nice rest for a week after today. I'll probably unplug it from the mains while I'm away then see what it's up to when I get back. (I'll be online next week but not on this machine).

    Just been converting all my household spreadsheets from Microsoft Works to Excel - that was fun!

    My arguments never conflict though, do a search on google how to properly calibrate a battery. I'm correct :cool::cool:

    Anyways, enjoy your week off try to stay away from MSE, it is addictive :)
    Owner of andrewhope.co.uk, hate cars and love them

    Working towards DFD

    HSBC Credit Card - £2700 / £7500
    AA Loans - (cleared £9700)
  • thescouselander
    thescouselander Posts: 5,547
    Part of the Furniture 1,000 Posts Name Dropper Combo Breaker
    Forumite
    edited 15 July 2010 at 1:14PM
    Lil306 wrote: »
    To properly calibrate a battery it should be fully discharged, recharged, then discharged again. Which means running on batteries until the laptop loses all power and shuts off completely. If you run it to 50% only, then the battery loses it's memory and effectively think it's life cycle is the remaining 50%. Thats why you have to let them shutdown completely, this then makes the battery do a full recharge cycle and another full discharge to learn it's life cycle.

    After that it can be plugged into mains and can be used as normal

    When it's calibrated in BIOS, you normally press something like F1/F2 or Del for BIOS, there may be a power section. Then battery calibration


    Yes, its difficult to know what to do and the charging circuits in some Laptops do complicate things. Deeply discharging a Lithium Polymer battery is a definite way to degrade the cells though.


    I have never calibrated the battery on my Macbook and have never encountered any problems. Generally when charging Lipo batteries the charging circuit will charge the battery until each cell is at 4.2 volts so you should always get a full charge. I strongly suspect this battery calibration malarkey is a hangover from the days of NiMH battery technology where the charge state was more difficult to predict. With the newer LIPO batteries remaining charge is pretty much proportional to cell voltage therefore battery calibration shouldn't be necessary (in theory at least).
This discussion has been closed.
★ ★ ★ Meet your Ambassadors

🚀 Getting Started

Hi new member!

Our Getting Started Guide will help you get the most out of the Forum

Categories

  • All Categories
  • 356K Banking & Borrowing
  • 255K Reduce Debt & Boost Income
  • 456.3K Spending & Discounts
  • 248.5K Work, Benefits & Business
  • 606.2K Mortgages, Homes & Bills
  • 179.1K Life & Family
  • 264K Travel & Transport
  • 1.5M Hobbies & Leisure
  • 16.2K Discuss & Feedback
  • 37.7K Read-Only Boards
Quick Search

Is this how you want to be seen?

We see you are using a default avatar. It takes only a few seconds to pick a picture.