Ready, steady… save!
You don’t need a chart to join in. Here are 2 ways to record your savings:
1. Cross it off
Pop a chart into your first post. Saved an amount? Cross it out! Read more »
£0.01 £0.02 £0.03
2. Write it down
Skip the chart and add updates to your first post. Read more »
“Another +£3 saved today. Go me!”
Use +£ before each new saving so it counts towards your total.
📨 Have you signed up to the Forum's new Email Digest yet? Get a selection of trending threads sent straight to your inbox daily, weekly or monthly!
Restore using factory.wim
blammo
Posts: 95
Forumite
in Techie Stuff
hi, I have a dell dimension c521 which I want to restore using the factory.wim file on the 
\ recovery drive.
Does anyone have any hints or tips or know any good instructions on line?
thanks
\ recovery drive.Does anyone have any hints or tips or know any good instructions on line?
thanks
0
Comments
-
normally CTRL and F11 as the PC boots gives you access to the restore menu, see page 56
http://support.dell.com/support/edocs/systems/dimc521/en/OM_EN/RP333A00.pdf
on some later ones it was F12 to access a repair menu and it was on there , but the manual indicates the aboveEx forum ambassador
Long term forum member0
This discussion has been closed.
Confirm your email address to Create Threads and Reply
Categories
- All Categories
- 355.9K Banking & Borrowing
- 255K Reduce Debt & Boost Income
- 456.2K Spending & Discounts
- 248.4K Work, Benefits & Business
- 606.1K Mortgages, Homes & Bills
- 179K Life & Family
- 263.9K Travel & Transport
- 1.5M Hobbies & Leisure
- 16.2K Discuss & Feedback
- 37.7K Read-Only Boards